Amylior GROUP 22 Manual

1 IG ǀP18034 ǀ1003754 ǀRev.01
GROUP 22/21 BATTERY CONNECTIONS
WITH COVERS
GROUPE 22/21 CONNECTIONS
Diagram (A)
The information label for connecting battery cables is located on the inside of the battery access door as
shown in image A below.
Connection sequence of cables
STEP 1
Slide covers to have access to the terminals and to
pull the wires for connection, as shown in image B.
B

GR. 22 BATTERY CONNECTION (cont’d)
2 IG ǀP18034 ǀ1003754 ǀRev.01
—NOTES —
When connecting the cables to the battery, it is
important to follow the sequence of the hardware
as shown in the illustration below.
Make sure that the connectors on the terminals
remain down so as not to interfere when closing
covers, as shown in image below.
STEP 2
Connect breaker cables (1 & 2) and connector
cables (3 & 4) according to the number
sequence shown in image C.
STEP 3
Lift covers slightly to close over terminals as
shown in image D.
STEP 4
The strap must be routed parallel along both batteries over the covers, as shown in image E.
C
D
E