Amylior Gs 100 Manual

1 IG - PD-A20607 - Gs100 - March 2021 - R01
Gs100
ASSEMBLY FOR AUTHORISED DEALER
Use the following instructions to assemble the Gs100 scooters for a customer.
1. VERIFYING THE TILLER’S MOVEMENT
Verify that the grooves on the hinge fit into each other and make sure that the tightening handle is tight.

2 IG - PD-A20607 - Gs100 - March 2021 - R01
2. UNLOCKING THE TILLER
a) Open the cover located at the base of the tiller.
b) Press the button.
c) Turn the button counterclockwise. Close the cover.

3 IG - PD-A20607 - Gs100 - March 2021 - R01
3. VERIFYING THE DRIVE TRAIN LATCH
Checking the latch on the rear component for dismantling.
a) Remove seat and batteries if installed.
b) Lift latch. This will also lift the front part to separate the rear component from the scooter.
c) To reassemble the front part to the rear train, both parts must be perfectly aligned.
d) Allow the front part to lower itself onto the rear train.
e) Gravity should allow the lever to latch itself (ideally), but in case it does not, press down lightly.

4 IG - PD-A20607 - Gs100 - March 2021 - R01
4. INSTALLING THE BATTERY PACK
a) Raise the tightening handle.
b) Slide the battery pack into position.
c) Lower the tightening handle.
d) Tighten the handle to hold the battery pack in
position.

5 IG - PD-A20607 - Gs100 - March 2021 - R01
5. INSTALLING THE SEAT
a) Slide the seat post into the tube provided for this purpose.
b) Rotate the seat using the release handle on the right-hand side of the seat. If it is properly installed
the seat should lock after 1/8 of a turn.
6. INSTALLING ARMRESTS
a) Slide armrest into the square tube on the seat frame.
b) Place armrest as close as possible to the backrest without touching it.
c) Tighten securely using the tightening nobs, turning clockwise.

6 IG - PD-A20607 - Gs100 - March 2021 - R01
INSTALLING THE SAFETY BELT (OPTIONAL ACCESSORY)
a) Remove the tightening nobs holding the armrests.
b) Slide the belt ring onto the nob’s thread.
c) Securely screw nob back onto the seat frame.

7 IG - PD-A20607 - Gs100 - March 2021 - R01
8. INSTALLING REAR-VIEW MIRROR AND CELL PHONE HOLDER (OPTIONAL)
a) Attach the clamp around the handlebar.
b) Insert the rear-view mirror rod into the hole on the clamp.
c) Place the cell phone holder (optional accessory) in
between the clamp and the mirror’s locknut.
d) Tighten the mirror by turning clockwise.
e) Once the mirror is in the desired position, tighten locknut using a 14 mm hex wrench.
f) Slide the protective cover back onto the locknut.

8 IG - PD-A20607 - Gs100 - March 2021 - R01
9. INSTALLING THE FRONT BASKET
Slide the basket down onto the metal bracket located on the front of the tiller until tabs are latched.
10. TIRES
Inflate 4 tires at 40 PSI