Amylior Gs200 Manual

1 IG - PD-A20607 - Gs200/300/500 - March 2021 - R01
Gs200 / Gs300 / Gs500
ASSEMBLY FOR AUTHORISED DEALER
Use the following instructions to assemble Gs200, Gs300 or Gs500 scooters for a customer.

2IG - PD-A20607 - Gs200/300/500 - March 2021 - R01
1. INSTALLING SEAT ONTO SCOOTER
a) Slide the seat post into the tube provided for this
purpose.
b) Rotate the seat using the release handle on the
right-hand side of the seat. If it is properly
installed the seat should lock after 1/8 of a turn.
2. INSTALLING ARMRESTS
a) Slide armrest into the rear square tube on the
seat frame.
b) Place armrest as close as possible to the backrest
without touching it.
c) Tighten securely using the nobs and turning
clockwise.

3IG - PD-A20607 - Gs200/300/500 - March 2021 - R01
3. INSTALLING ACCESSORY RECEPTACLE
Using a 5 mm Allen key and a 14 mm hex wrench, install the rear
accessory receptable on the tube of the seat frame with warning label
facing up.
4. INSTALLING REAR STORAGE COMPARTMENT (OPTIONAL ACCESSORY)
a) Using a 5 mm Allen key remove the two top screws on the backrest supports.
b) Center the storage compartment bracket on the backrest using the oblong holes. Put the original
screws back in their location and tighten securely.

4IG - PD-A20607 - Gs200/300/500 - March 2021 - R01
c) Align the 3 holes behind the storage compartment so that the tabs from the metal bracket insert into
the compartment (not shown). Tighten the screw inside the storage compartment manually clockwise.
5. INSTALLING REAR-VIEW MIRRORS AND CELL PHONE HOLDER (OPTIONAL)
Rear-view mirrors:
a) The rear-view mirrors are identified with Lfor left and Rfor
right. Make sure they are installed in the proper location.
b) Attach the clamp around the handlebar.
c) Insert the rear-view mirror rod into the hole on the clamp.
Cell phone holder (optional accessory):
•Slightly bend the metal ring that connects to the clamp.
•Place the ring in between the clamp and the rod’s locknut.
•Install on the right-hand side unless otherwise specified.

5IG - PD-A20607 - Gs200/300/500 - March 2021 - R01
Rear-view mirrors (continued):
d) Tighten the mirror by turning clockwise.
e) Once the mirror is in the desired position, tighten locknut using a 14 mm hex wrench.
f) Slide the protective cover back onto the locknut.
6. INSTALLING THE BLUETOOTH SOUND BAR (OPTIONAL ACCESSORY)
Note : The Bluetooth sound bar User’s Guide is also on
Amylior’s website under Products / Gs Series Scooters.
a) Along with the sound bar, the package contains 2 thick
self-adhesive foam strips, a USB connection cable for
charging, a tightening screw, and the User’s Guide sheet.
b) Stick both foam strips on the sound bar mount (1002640)
as shown.
c) To install mount, use 2 screws (E00110) and
2 spacers (for Gs200/300 only) 1002716.
d) Remove both original screws from handlebar.

6IG - PD-A20607 - Gs200/300/500 - March 2021 - R01
e) To install mount, both spacers (1002716) are only used for Gs200 and Gs300 scooters, but both
screws (E00110) are use for all 3 scooters, as shown below.
Gs200 et Gs300
Gs500
f) Place sound bar on mount
g) Insert the tightening screw in the mount’s
oblong slot, screw into sound bar and tighten
in desired position.
7. INSTALLING THE BASKET AND FRONT STORAGE COMPARTMENT (OPTIONAL)
Basket: Slide the basket down onto the metal bracket located on the front of the tiller until tabs are
latched.

7IG - PD-A20607 - Gs200/300/500 - March 2021 - R01
Front storage compartment (Optional accessory) :
a) Align the 3 holes behind the storage compartment so that
the tabs from the metal bracket insert into the
compartment (not shown).
b) Tighten the screw inside the storage compartment
manually clockwise.
8. INSTALLING SAFETY BELT (OPTIONAL ACCESSORY)
Using a 5 mm Allen key, remove original screw from the seat frame as shown below. Place the belt’s ring
onto the screw and securely tighten screw onto the frame.
9. TIRES
Inflate 4 tires at 40 PSI

8IG - PD-A20607 - Gs200/300/500 - March 2021 - R01
The following applies to Gs300 and Gs500 scooters only.
10. INSTALLING HEADREST
Align headrest posts with the holes on the top of the backrest and push down.
Note : The scooters’Owner’s Manual are all on Amylior’s website under
Products / Gs Series Scooters.