
Page 9 of 13
Press again and the controller will turn Off and go into standby. The indicator
light will turn off.
7. Mode Button (5 Modes): With the Controller switched on and the On / Off button
pressed the Massager will start in default Mode 1 and Medium Intensity.
The “M1” Indicator light will illuminate.
Description of Mode 1: alternating massaging cycle from Neck to Leg. - Repeat
Press this button again, and the massager mode will change to Mode 2 and the
“M2” Indicator light will illuminate.
Description of Mode 2: alternating massaging cycle from Back to Leg to Neck to
Thigh. - Repeat
Press this button again, and the massager mode will change to Mode 3 and the
“M3” Indicator light will illuminate.
Description of Mode 3: alternating massaging cycle from Back to Thigh to Back
to Leg to Neck to Leg to Neck to Thigh. - Repeat
Press this button again, and the massager mode will change to Mode 4 and the
“M4” Indicator light will illuminate.
Description of Mode 4: alternating massaging cycle from Back to Thigh to Back
to Thigh to Back to Leg to Back to Leg to Neck to Leg to Neck to Leg to Neck to
Thigh to Neck to Thigh. - Repeat
Press this button again, and the massager mode will change to Mode 5 and the
“M5” Indicator light will illuminate.
Description of Mode 5: alternating massaging cycle intensity from low to high
through all massage zones. - Repeat
Press this button again, and the massager mode will cycle back around to Mode
1.
Note: During any of the pre-programmed Modes, you can adjust the intensity by
pressing the Intensity Button.
Pressing any of the four buttons “Neck”, “Back”, “Thigh” or “Leg” will cancel the
pre-programmed Mode and will enter Manual Mode.
You can select either of the four zones or a combination of the four.
Press the On / Off button to turn the massager off.