anko V8273-L-9 User manual

1
Vacuum Cleaner
User Manual
Model no.: VC8273-L-9
PLEASE READAND SAVE THESE
INSTRUCTIONS FOR FUTURE REFERENCE

2
IMPORTANT SAFEGUARDS
FOR HOUSEHOLD USE ONLY.
This appliance should only be used for domestic cleaning, and must only be used
indoors, as described in this user guide.
1. Always switch off and remove the charger from the socket before cleaning the
appliance or during any maintenance.
2. This appliance is not intended for used by persons (including children) with
reduced physical, sensory or mental capabilities, or lack of experience and
knowledge, unless they have been given supervision or instructions
concerning use of the appliances by a person responsible for their safety.
3. Children should be supervised to ensure that they do not play with the
appliance.
4. If the power cord is damaged, it must be replaced by a qualified electrician in
order to avoid hazard or the appliance must be disposed.
5. Use only the original charger supplied with the appliance.
6. Check that your supply voltage is the same as that stated on the charger.
7. When charging the appliance, the power switch must be off.
8. Never charge the batteries in temperatures above 37°C or below 0°C.
9. It is normal for the charger to become warm to the touch when charging.
10. Use only attachments provided.
11. Static electricity: some carpets can cause a small build up of static electricity. Any
static discharge is not hazardous to health.
12. Do not use your appliance out of doors or on any wet surface.
13. Do no spray with or pick up flammable liquids, cleaning fluids, aerosols or their
vapors.
14. Do no continue to use your appliance or charger if it appears faulty.
15. Do not leave the appliance unattended when in use.
16. Never use the appliance without the filters in place!
17. Check the filters are inserted correctly!
18. Do empty the Dust Cup regularly for optimal operation of the vacuum.
19. Do not replace the batteries with non-rechargeable batteries.
20. The vacuum must only be used with the battery charger provided with the
product: WJA-Y081750400W.
WARNING: Do not recharge non-rechargeable batteries.
WARNING: Before charging the product, please make sure your hands are dry.
WARNING: Please use the charger supplied with the appliance. Other chargers may
cause electrical failure and/or fire.

3
End of Product Life Battery Disposal
If the cleaner is to be disposed of, the batteries should be removed.
The battery should be disposed safely and responsibly.
Used batteries should be taken to a recycling station and not disposed of with
household waste. To remove the batteries, please follow below instructions:
IMPORTATNT! Always fully discharge the batteries before removal and ensure
the charger is unplugged.
1. Run the vacuum cleaner until it stops. This will fully discharge the batteries.
2. Remove the ergonomic handle and the screws, in the main body to open the
vacuum cleaner.
3. Remove the motor housing and disconnect the cables.
4. Remove the batteries from the housing.
Note: DO NOT dispose batteries with normal household waste. Contact your local
council waste disposal service for proper battery disposal facilities available for our
area.

4
PARTS
A
B
Wall mount pack
B
Charger
C
Handheld Vacuum
D
Flip-up crevice tool
E
Brush
F
Rubber wiper
G
On/Off switch
H
Charging/ Power indicator
I
Dust cup release button
J
Dust cup
K
Cloth filter
CHARGING THE VACUUM
Plug the charger into the wall outlet, ensure the voltage of the electricity supply is same as that
indicated on the rating label of battery charger. When charging is completed, pull out the battery
charger from the socket.
When used for the first time, charge the vacuum cleaner for 6hrs. After first time use the normal
charging time is 5Hrs.
The indicator light will flash during charging, it turns to GREEN steady light when fully charged.
When the battery level is high, indicator light will remain GREEN, it turns RED when battery level is
low. When the battery power is low the Indicator light will flash for approximately 20 seconds before
the vacuum cleaner turn off automatically.
THE PRODUCT NEEDS TO BE CHARGED PERIODICALLY (2 or 3 TIMES A MONTH) TO
ENSURE OPTIMUM BATTTERY LIFE, EVEN IF YOU HAVE NO INTENTION OF USING IT FOR
A LONG TIME.

5
ASSEMBLY
IMPORTANT! The cloth filter must always be used when operating the
handheld vacuum.
A crevice tool is built into the nozzle
and can be flip-down for use.
A rubber wiper was provided for wet
suction.
Push the wiper to nozzle, ensuring it is
tightly fixed.
A brush was provided for general
cleaning.
Flip-down the crevice tool, then push
the brush attachment to crevice tool.
Ensure it is tightly fixed.

6
USING THE VACUUM
Turn on the vacuum cleaner by sliding
the On/Off switch forward.
(i.e. “O” = OFF, “I” = ON).
To stop, slide the switch back.
Recharge the vacuum after use.
MAINTENANCE
Emptying the dust cup
Press the dust cup release button and
pull out the dust cup
Pull out the filter.

7
Empty the dust cup.
Cleaning the filter
Wash the filter and dust cup under
rinsing water.
IMPORTANT! DO NOT wash the main
electric motor unit with handle in water
or other liquid.
Allow to dry for 24 hours.
Make sure filter and dust cup are dried
thoroughly before fitting them back to
the unit.
IMPORTART! Filters must be
cleaned regularly for best suction
performance and to prevent
over-heating and damaging the
vacuum cleaner.

8
STORAGE
Wall Mount
There is a wall mount accessory
supplied with screws and wall
plugs.
To install the wall mount bracket,
position it on the wall at a suitable
height.
Mark the two screw holes through
onto the wall. Using a suitable drill
(wood drill bit for timber wall, or
masonry drill bit for brick /
concrete walls, drill three holes
Ø6mm and 35 - 40mm deep.
Insert the plastic wall plugs into
each hole and gently hammer in
until they are flush with the wall,
place the hanging mount over the
holes then insert the screws and
tighten up. Do Not Overtighten.
Insert the DC jack through the
bottom hole of wall mount bracket,
twist in 90deg to hold it at base
Seat the handheld vacuum on the
wall mount bracket, the vacuum
can start charging in this position.
IMPORTANT! If unsure of the
above installation process consult
a professional person to have it
installed.

9
TROUBLE SHOOTING
Problem
Possible causes
Solutions
The vacuum cleaner does not
switch ON.
1. The power switch on the
unit is not switched to ON.
2. Bad contact to mains power
socket/ charger jack
1. Try sliding the power switch
button to ON again.
2. Check connection and see
if battery is fully charged
Suction not strong
1. Brush head not correctly
fitted.
2. The dust cup is full.
3. The filters are blocked.
1. Check brush head had
connected to main unit.
2. Empty dust cup.
3. Check for any blockages
and wash filter.
SPECIFICATION
Model number
V8273-L-9
Battery
14.8V 1300mAh, Li-ion
(3.7V x 4cells)
Working time:
15-20min
Charging time:
5-6hr
Battery charger
WJA-Y081750400W
Input:100-240V 50-60Hz 16W;
Output 17.5V d.c. 400mA

10
12 MONTH WARRANTY
Thank you for your purchase from Kmart.
Kmart Australia Ltd warrants your new product to be free from defects in materials and
workmanship for the period stated above, from the date of purchase, provided that the
product is used in accordance with accompanying recommendations or instructions where
provided. This warranty is in addition to your rights under theAustralian Consumer Law.
Kmart will provide you with your choice of a refund, repair or exchange (where possible)
for this product if it becomes defective within the warranty period. Kmart will bear the
reasonable expense of claiming the warranty. This warranty will no longer apply where
the defect is a result of alteration, accident, misuse, abuse or neglect.
Please retain your receipt as proof of purchase and contact our Customer Service Centre
on 1800 124 125 (Australia) or 0800 945 995 (New Zealand) or alternatively, via Customer
Help at Kmart.com.au for any difficulties with your product. Warranty claims and claims
for expense incurred in returning this product can be addressed to our Customer Service
Centre at 690 Springvale Rd, Mulgrave Vic 3170.
Our goods come with guarantees that cannot be excluded under theAustralian Consumer
Law. You are entitled to a replacement or refund for a major failure and compensation
for any other reasonably foreseeable loss or damage. You are also entitled to have the
goods repaired or replaced if the goods fail to be of acceptable quality and the failure does
not amount to a major failure.
For New Zealand customers, this warranty is in addition to statutory rights observed under
New Zealand legislation.