SC011 authorization setting:
Make sure correct wiring between M5 and SC011, power on them, then move slide switch to ‘PROGRAM MODE’ as
below:
Match registered fingerprint or swipe registered card on
M5, then SC011 will beep once, means authorized
successfully. Then move slide switch to right(OFF).
Wiegand 26 Wiring:
Let the 'Anviz Wiegand Switch' cable is not connected to the GND and make sure correct wiring between M5 and
Anviz SAC844 or other Access Controller as below:
Wiegand date output format:
①Anviz Wiegand date output format：
ALL registered users output devieces’ last eight serial number.(For example, SN of one device is
1050000014470004, then Anviz Wiegand output 14470004.)
② Wiegand 26 date output format:
Card user: Output card number.(Decimal)
Fingerprint user: Output ID number.
③ Wiegand output format cann’t set by PC software and even if you have set it’s invalid, just exchange the
‘Anviz Wiegand Switch’ wiring.
