AnyDATA ADU-E100D User manual

AnyTime AnyPlace AnyWireless Data Solutions™
1
ADU-E100D
AnyDATA USB Modem
User Manual
V7.0.0
2006.5.19

AnyTime AnyPlace AnyWireless Data Solutions™
2
AnyDATA CDMA Module Series USB Modem Reference Design Specification
Copyright © 2005 AnyDATA Corp. All Rights Reserved.
Any part of this document may not be distributed, communicated, reproduced or transmitted in
any form or by any means, electronic or mechanical or otherwise, for any purpose, without the
permission of AnyDATA Corp.
AnyDATA Inc. does not assume any liability arising out of the application or use of its products.
AnyDATA Inc. assumes no responsibility for any damage or loss resulting from the misuse of its
products. AnyDATA Inc. assumes no responsibility for any loss or claims by third parties, which
may arise through the use of its products. AnyDATA Inc. assumes no responsibility for any
damage or loss caused by the deletion or loss of data as a result of malfunctions or repairs
This document can be subject to revision without further notice.
Contact Address
Headquarter
AnyData Corporation
18902 Bardeen Ave, lrvine,
CA 92612-1522 U.S.A.
http://www.anydata.com
e-mail: [e-mail]
Rep:1-949-833-0011
Fax: [phone]
AnyData(China)
489 Song Tao Road, Sector B,
1 st Fl. Pudong ZhanJiang Hi-
Tech Park, Shanghai, 201203,
P.R.China
http://www.anydata.net.cn
e-mail: [e-mail]
Rep:[phone]
Fax:[phone]
AnyData.Net Inc.(Korea)
DaeGo Bldg, 8 th., 1591-10
Kwanyang-dong, Dongan_gu,
Anyang City, Kyunggi-do Korea.
http://www.anydata.co.kr
e-mail: [e-mail]
Rep:[phone]
Fax:[phone]
!
Warning: Exposure to Radio Frequency Radiation
The radiated output power of this device is far below the FCC radio frequency
exposure limits. Nevertheless, the device should be used in such a manner that the
potential for human contact during normal operation is minimized. In order to avoid
the possibility of exceeding the FCC radio frequency exposure limits, human proximity
to the antenna should not be less than 20cm during normal operation and the gain of
the external antenna must not exceed 1dBi.
This device contains AnyDATA DTEV-DUAL module whose FCC ID is
P4M-DTEVDUAL and IC certificate number is 4594A-DTEVDUAL

AnyTime AnyPlace AnyWireless Data Solutions™
3
Contents
0. Revision History
1. About AnyDATA USB MODEM
(1) Product Description and Feature
(2) Technical Specification
2. Getting Started
(1) USB Modem Components
A) LED indicator Information
B) Other Components
3. Program Installation
(1) Introduction
(2) Minimum System requirement
A)PCHardware
B) Operating System
(3) Installing Easy Wireless Net Software
(4) Connecting to AnyDATA USB Modem and Driver installation and Uninstallation
A) Proper connection and Driver Installation
B) Checking the proper installation of the Driver
C) Uninstallation
4. Using Easy Wireless Net program
(1) Running the program
(2) Exiting the program
(3) Screen display of Easy Wireless Net
A) Executed Screen
B) Window for information and input
C) Description of each icon
(4) Setting environment
(5) Connecting to Internet
(6) Disconnecting from the Internet
(7) Sending and Receiving calls.
(8) Sending and Receiving SMS.
A) Writing New Message.
B) Viewing Sent Message.
C) Viewing Received or Saved Message.
5. Troubleshooting.
6. Quick Guide

AnyTime AnyPlace AnyWireless Data Solutions™
4
0. Revision History.
The revision history for this manual is show.
Revision History
Version Date Description
1.0 May. 14. 2005 Initial release – AnyDATA USB Modem
1.1 May. 16. 2005 Add Hardware Information
1.2 May. 17. 2005 Uct e-mail id change
2.0.0 July. 4. 2005 1. Version Recreate – manual flow
2. Troubleshooting. add
3. Quick Guide add
3.0.0 July.8.2005 Modify Troubleshooting.
Hangul Font Removed
Etc…
4.0.0 July. 14. 2005 Bug And Capture Image
5.0.0 Aug. 1. 2005 LED operation change
Add hardware technical standards
Add Power Key operation
Add FCC warning statement
6.0.0 May. 19.2006
Removed UIM Function for ADU-E100D V3.0U
Removed voice/SMS support

AnyTime AnyPlace AnyWireless Data Solutions™
5
1. About AnyDATA USB MODEM
(1) Product Description and Feature
In today’s fast-moving economy, the need to remain connected is essential. The world’s most
compact EVDO USB modem, ADU-E100D, offers the appropriate solution to home and mobile
connectivity using antenna diversity that enables better connectivity and data speed in poor
signal environment and internal antenna technology. It provides extensive and reliable wireless
data communication at speed up to 2.4Mbps downlink and 153kbps uplink, The AnyDATA EVDO
USB modem connects to USB port, and the application software effortlessly integrates into a
Windows based PC as well as notebook computer.
- EVDO technology based on Qualcomm MSM6500 chipset
- Support CDMA EVDO and 1xRTT
- High speed wireless data up to 2.4Mbps downlink and 153kpbs uplink
- Internal antenna supporting diversity
- 4 LEDs
- Support USB 2.0 interface with PC
- Battery included, 1660mAh

AnyTime AnyPlace AnyWireless Data Solutions™
6
(2) Technical Specification
Technical Standard - CDMA EVDO
- CDMA 1xRTT
- TCP/IP and PPP
RF Technology - Antenna Diversity
- Internal Antenna
Electrical - Sensitivity : Lower than –104dBm
- Transmit Power : 400mW(26dBm) max.
- 4 LED indicators
Input Power - External Power : DC 5V
- Battery : 4.2V Li-Ion, 1660mAh
Interface - Mini-B type USB
- DC Power Jack
- External Antenna Port
Current Consumption - Traffic Mode: 750mA max. at 5V
- Idle Mode : 110mA
- Sleep Mode : 9mA
Antenna - Two internal antennas to support diversity
Data Speed - Download: 2.4Mbps max.
- Upload : 153kbps
System Requirement - Windows 2000/XP
- USB Port
- Above 64MB RAM
Frequency -RX :869.04MHz~893.37MHz,1931.25MHz~1988.75MHz
-TX :824.04MHz~848.97MHz,1851.25MHz~1908.75MHz
Size - 100mm(L)*56mm(W)*14mm(H) without battery
- 100mm(L)*56mm(W)*25mm(H) with battery
Weight - 61g without battery
- 124g with battery
Software Spec. - CDMA2000 High rate packet data air interface
- CDMA 1xRTT, IS-95A/B
- IS-637A
- IS-707-A
- IS-837, IS-856, IS-866, IS-890
Hardware Spec. - IS-98E
- IS-866
Environmental - Operating Temperature: -30℃~ 60℃without battery
- -20℃~ 50℃with battery

AnyTime AnyPlace AnyWireless Data Solutions™
7
2. Getting Started
In order to use theAnyDATA USB MODEM, the following must be satisfied:
1. Easy Wireless Net Software and AnyDATA USB MODEM Driver have been installed on the
computer.
2. Must have a proper user name and password from the local CDMA operator.
3. AnyDATA EVDO USB MODEM must have certification from the local CDMAoperator.
CAUTION: PLEASE CONNECT THE BATTERY OR EXTERNAL AC/DC ADAPTOR TO
INSURE OPERATION OF THE MODEM. USING THE MODEM ON-THE-ROAD,
PLEASE KEEP BATTERY INTACT WITH THE MODEM. AND MAKE SURE THE
BATTEY IS FULLY CHARGED BEFORE USING. WHEN THE BATTEY VOLTAGE
IS LOW, MAKE SURE TO CHARGE IT BEFORE CONTINUING TO USE.

AnyTime AnyPlace AnyWireless Data Solutions™
8
(1) USB Modem Components
IDLE LED
BUSY
LED
POWER LED
POWER KEY
+5V DC
POWER JACK Mini USB Port
INTERNAL
ANTENNA

AnyTime AnyPlace AnyWireless Data Solutions™
9
* Caution : When dismounting the battery, push the bottom of modem upward to slide easily out
from the battery cradle.
Battery
Contact Switch
Primary Channel
RF Test Port
Battery Contact
Pins
Second Channel
RF Test Port

AnyTime AnyPlace AnyWireless Data Solutions™
10
A) LED indicator Information
1. POWER :
• Red : Modem is on.
• Off : Modem is off.
2. IDLE (Service/Mode) :
• Blue : In service area
• Off : Out of service area
3. BUSY (Traffic) :
• Blue : Data call connected
• Off : Not in connection

AnyTime AnyPlace AnyWireless Data Solutions™
11
B) Other Components
1. Internal Antenna
• Two antenna for diversity reception are already installed in the device.
2. +5V DC Power Jack
• +5V main power supply to USB modem and is used for charging. Modem works with external
+5V power only.
3. Mini USB Port
• Connected to desktop or notebook computer.
• Modem doesn’t work if both of battery and AC/DC adaptor are removed.
4. Ear Jack (Not Supported)
5. Battery Contact Switch
6. External Antenna Port
• Used as a test port in manufacturing.
7. Battery Contact Pins
8. Power Key
• Press shortly to turn the modem on
• Press for more than 2 seconds then release to turn off the modem

AnyTime AnyPlace AnyWireless Data Solutions™
12
3. Program Installation
(1) Introduction
This section describes a step-by-step method to install the AnyDATA USB MODEM and the
Easy Wireless Net Software.
Note : Must install the software before connecting the AnyDATA USB MODEM to PC/Notebook.
(2) Minimum System Requirement
A) PC Hardware
Recommended: PC/Notebook at speed of 300 MHz or higher.
Minimum: 233 MHz speed required, * Intel Pentium/Celeron products,
AMD K6/Athlon/Duron products or compatible processors
Recommend to use 128MB RAM or higher
Minimum 64MB of memory must be used,
but in this case the performance will be degraded and certain features will be limited.
Required: At least 100 MB of free hard disk space is required.
Motherboard or PCI card that supports USB.
Video adaptor with Super VGA (800 x 600) or higher resolution and Monitor
CD-ROM or DVD Optical Drive
Keyboard and Mouse
B) Operating System
Windows XP Home or Professional
Windows 2000 (with Service Pack 3 for optimal performances)

AnyTime AnyPlace AnyWireless Data Solutions™
13
(3) Installing Easy Wireless Net Software.
1. Double click “setup.exe” from the supplied CD.
2. Select the desire language as shown below.
3. Press button to proceed.
By pressing button, the installation of the Easy Wireless Net Program will stop.
4. Welcoming message for using the Easy Wireless Net Program window will appear.
5. Press button to proceed.

AnyTime AnyPlace AnyWireless Data Solutions™
14
6. Next window is related to License Agreement. Please read carefully.
7. Press “I Agree” button to advance to the next step.

AnyTime AnyPlace AnyWireless Data Solutions™
15
8. Next window asks for the proper path for installing the program.
Default path is “C:\Program Files\Easy Wireless Net”.
9. Press button to install the program.

AnyTime AnyPlace AnyWireless Data Solutions™
16
10. When program has been successfully installed, following window will display.
11. Press button for ending the program installation.
The Easy Wireless Net program is now installed on your computer.
<Remark>
If modem is not connected to the PC/Notebook and the device driver is not installed, then the
program will not launch even after completion of this installation program.
Device driver installation is explained in the next section.

AnyTime AnyPlace AnyWireless Data Solutions™
17
(4) Connecting to AnyDATA USB MODEM and Driver Installation
and Uninstallation
A) Proper connection and Driver Installation
1. Connect the modem to the PC’s USB port using the supplied USB cable.
2. Installing “AnyDATA USB Modem Driver” window will appear.
Select “Install from a list or specific location (Advanced)”.
3. Press button to proceed.
4. A window that asks for the proper path of the Driver will appear.
5. Select from the CD’s path “CDRomDirve:\Driver\” folder for appropriate OS.
6. Press button to proceed.

AnyTime AnyPlace AnyWireless Data Solutions™
18
7. Windows that searches for the “AnyDATA CDMA USB Modem Device.”
8. If windows finds the “AnyDATACDMA USB Modem” it will asks for installation.
9. Press button to move to the next step.

AnyTime AnyPlace AnyWireless Data Solutions™
19
10. In the process of installing “AnyDATA CDMA USB Modem” Driver.
11. If the installation of “AnyDATA CDMA USB Modem” has been successfully completed, the
following window will appear.

AnyTime AnyPlace AnyWireless Data Solutions™
20
12.Next, Install the “AnyDATACDMA USB Serial Device” Driver.
13. Select “Install from a list or specific location (Advanced)”.
14. Press button to proceed.
15. Select the proper path from the CD window.
16. Select from the CD’s path “CDRomDirve:\Driver\” folder for appropriate OS.
17. Press button to move to next step.