APURO GF455-A User manual

Pie Warmer
Instruction manual
Model: GF454-A/GF455-A

Saf e ty Tips
• Position the appliance on a flat, stable surface.
• When positioning the appliance, maintain a distance of 20cm (7 inches) between the
appliance and walls or other objects for ventilation. Increase this distance if the
obstacle is a heat source.
• A service agent/qualified technician should carry out installation and any repairs if
required. Do not remove any components or service panels on this product.
• Consult Local and National Standards to comply with the following:
• Health and Safety at Work Legislation
• BS EN Codes of Practice
• Fire Precautions
• IEE Wiring Regulations
• Building Regulations
• DO NOT immerse the Pie Warmer in water, or use jet/pressure washers to clean it.
• Always switch off and disconnect the power supply to the appliance before cleaning.
• Always allow the Pie Warmer to cool down before cleaning, maintaining or moving to
avoid the risk of burns.
• DO NOT use the appliance for anything other than its intended use.
• This appliance must only be used in accordance with these instructions and by persons
competent to do so.
• This appliance is not suitable for use by children.
• Keep all packaging away from children. Dispose of the packaging in accordance to the
regulations of local authorities.
• If the power cord is damaged, it must be replaced by an APURO agent or a
recommended qualified technician in order to avoid a hazard.

Telephone Helpline: 1300 225960
Intr oduction
Please take a few moments to carefully read through this manual. Correct maintenance
and operation of this machine will provide the best possible performance from your
APURO product.
Pa c k C o n t e n t s
The following is included:
• Pie Warmer • Wire rack x 3
• Sliding glass door x 2 • Element Guard
• Glass display panel • Water Reservoir
APURO prides itself on quality and service, ensuring that at the time of packaging the
contents are supplied fully functional and free of damage. Should you find any damage as a
result of transit, please contact your APURO dealer immediately .
Instal lati on
To install the Pie Warmer:
1. Remove the Pie Warmer from the packaging. Make sure that all protective plastic film and
coatings are thoroughly removed from its surfaces.
2. Take the glass display panel and raise it at an angle into the upper track at the rear of the unit
[Fig. 1] .
3. Once at the top of the track, position the bottom of the glass above the lower track [Fig. 2] .
4. Carefully lower the glass into the bottom track [Fig. 3] .

5. Slide the wire racks into the bracket on the inner side of the Pie Warmer.
6. Insert the two sliding door panels in the same manner as the display panel. Ensure the
handles are located towards the outside edges of the appliance [Fig. 4].
7. Connect the plug to a suitable mains socket and turn on the power supply.
Operation
1. Add water (0.5L) to the water reservoir
2. Set the thermostat to the desired temperature.
3. The unit will cycle on and off to maintain the set temperature.
The green indicator light and illuminated interior lamp shows when the unit is switched on
The red indicator light shows when the desired temperature has been reached.
Cleaning, Car e and Maintenance
• Always turn off the appliance and disconnect from the power supply before cleaning.
• Allow the appliance to cool before cleaning.
• The inner body of the appliance should be wiped down at the end of each day's
operation. Additional cleaning may be required depending on frequency of use.
• Warm soapy water is recommended for cleaning. Cleaning agents may cause damage or
leave harmful residues when used for a prolonged period on stainless steel.
• A APURO dealer or qualified technician should carry out repairs if required.

Telephone Helpline: 1300 225960
Tr o ub l e s h oo t i n g
If your APURO Pie Warmer develops a fault, please check the following table before making a
service call.
Fault
Probable Cause
Action
The unit is not heating
up and the green
indicator light is Off
The unit is not switched on
Check the unit is plugged in correctly
and switched on
switched on
Plug and lead are damaged
Call APURO agent or qualified
technician
Fuse in the plug has blown
Replace the plug fuse
Power supply
Check power supply
Internal wiring fault
Call APURO agent or qualified
technician
The unit heats up but
the red indicator light is
Off
Indicator light is faulty
Call APURO agent or qualified
technician
The unit is not heating
up or heats up slowly
and the indicator light is
On
Incorrect operation
Ensure:
• thermostat has been set correctly
• doors are closed
• thermostat sensor bulb has not
been removed or damaged
Thermostat failure
Call APURO agent or qualified
technician
Element failure
Call APURO agent or qualified
technician
T e chnical Specif ications
Model
Voltage
Power
Current
Dimensions
h x w x d
(mm)
Weight
(kg)
Approx.
Pie
Capacity
Heat up
Time
(to90°C)
Operating
Temperatu
re Range
GF454-A
220-240V
50Hz
350W
1.5A
500 x 595 x390
16
30
27 minutes
30 - 90°C
GF455-A
220-240V
50Hz
650W
2.8A
582 x 755 x390
23
60
28 minutes
30 - 90°C

Electrical Wiring
This appliance is supplied with a 3 pin, moulded, AUS plug and lead, with a 13 amp fuse as
standard. The plug is to be connected to a suitable mains socket.
This appliance is wired as follows:
• Live wire (coloured brown) to terminal marked L
• Neutral wire (coloured blue) to terminal marked N
• Earth wire (coloured green/yellow) to terminal marked E
This appliance must be earthed, using a dedicated earthing circuit
If in doubt consult a qualified electrician.
Electrical isolation points must be kept clear of any obstructions. In the event of any
emergency disconnection being required they must be readily accessible.
Compliance
The WEEE logo on this product or its documentation indicates that the
product must not be disposed of as household waste. To help prevent
possible harm to human health and/or the environment, the product must
be disposed of in an approved and environmentally safe recycling
process. For further information on how to dispose of this product
correctly, contact the product supplier, or the local authority responsible
for waste disposal in your area.
APURO parts have undergone strict product testing in order to comply
with regulatory standards and specifications set by international,
independent, and federal authorities.
APURO products have been approved to carry the following symbol:
All rights r e served. No part of these instruc t io ns may be pr oduced o r tr ansmi t ted in any form o r by any means,
elect r onic, mechanical, phot o copy ing, rec ording or other w ise, without the prior written perm ission of APURO .
Eve r y e ffort is made t o ensure all det a ils are c o rre ct at the tim e of going t o press, however , APURO r e serve the
right t o change specifi c a t i ons w i thout notice .

DECLARAT I ON OF CONFORM I TY
Equi pm en t T y p e Pie Warmer
Mo del GF454-A / GF455-A
Legisl at ion C - T ick
AS /N Z 3820 Esse nt ial S a fety Requirem e nts for Low
Vol t age Elec trica l Equipment
S t andards E N 55014-1 : 2006, EN 55014 -2:1 997 +A1
EN 61000-3 - 2: 2006, EN 61000-3- 3:1 995 +A1+ A2
EN 60335-2 - 37 :20 02+ A1
EN 60335-1 : 2002+ A11+ A1+ A 12 +A2+A13 wit h AS/N ZS
60335 -1:2 002 + A1+A2 + A3 , EN 62233 :20 08
Prod
ucer Name Apuro
Prod
uc e r Addre ss 15 Badgally Road ,
Campbelltown ,
N S W 2560
I , th e un der s igned, h e re by de clare tha t th e eq uipm ent sp ecif ied above c o nf or ms to the
above Legislation and Standar d(s).
Da te 05 /0 3/13
Sign ature
F ull N a m e R i c ha r d Crom well
Position Marketing Dir e ctor

GF454-A _GF455-A_A5_v2