APURO CC039-A User manual

Crepe Maker
Instruction manual
Model
CC039-A

1
Safety Tips
• Position the appliance on a flat, stable surface.
• A service agent/qualified technician should carry out installation and any repairs if required. Do not
remove any components on this product.
• Consult Local and National Standards to comply with the following:
• Health and Safety at Work Legislation
• Fire Precautions
• IEE Wiring Regulations
• Building Regulations
• DO NOT immerse the appliance in water.
• DO NOT touch the top of the appliance when in use. Surfaces are hot!
• DO NOT obstruct or cover the appliance in any way when in use.
• DO NOT use an extension cable to power the appliance.
• Always switch off the appliance, disconnect the power supply and allow to cool before cleaning or
carrying out maintenance.
• Always switch off and disconnect the power supply to the appliance when not in use.
• Keep all packaging away from children. Dispose of the packaging in accordance to the regulations of
local authorities.
• If the power cord is damaged, it must be replaced by a Apuro agent or a recommended qualified
technician in order to avoid a hazard.
• This appliance is not attended for use by persons (including children) with reduced physical, sensory
or mental capabilities, or lack of experience or knowledge, unless they have been given supervision or
instruction concerning the use of the applaince by a person responsible for their safety
Introduction
Please take a few moments to carefully read through this manual. Correct maintenance and operation of
this machine will provide the best possible performance from your Apuro product.
Pack Contents
The following is included:
Apuro prides itself on quality and service, ensuring that at the time of packaging the contents are supplied
fully functional and free of damage.
Should you find any damage as a result of transit, please contact your Apuro dealer immediately.
• Apuro Crepe Maker
• Wooden Spatula
• Wooden Spreader
• Instruction Manual

2
Telephone Helpline: 130 0225960)
Operation
The appliance can be turned On or Off using the Temperature knob on the base.
Seasoning the Hot Plate
1. Before using for the first time the cooking surface needs to seasoned. This will create a 'non-stick'
surface on the hot plate.
2. Ensure the cooking surface is clean.
3. Brush the surface with cooking oil.
4. Connect the appliance to the mains power supply.
5. Set the thermostat to 110°C and turn the appliance On. The power indicator light turns on.
6. Once the appliance reaches temperature the power indicator light turns off.
7. Turn the appliance Off and allow to cool before wiping away any excess oil.
8. The appliance is now ready to use. Repeat as neccessary throughout the life of the appliance.
Making Crepes
1. Connect the appliance to the mains power supply.
2. Set the Temperature knob to the desired temperature. The
power indicator light comes on.
3. Once the appliance reaches the set temperature the power
indicator light turns off.
4. Pour the required amount of batter mixture on to the hot
plate.
5. Spread the mixture in a circular motion around the
hotplate with the spreader [Fig. 1].
6. Cook on one side before flipping with the spatula to cook the other side of the crepe.
Cleaning, Care & Maintenance
• A Apuro dealer or qualified technician should carry out repairs if required.
• Always switch off the appliance, disconnect the power supply and allow to cool before cleaning or
performing maintenance.
• If necessary wipe the exterior with a soft cloth and warm soapy water.
•Drythoroughlyafter cleaning.
Fig. 1

3
Troubleshooting
If your Apuro appliance develops a fault, please check the following table before making a call to the
Helpline.
Technical Specifications
Electrical Wiring
The plug is to be connected to a suitable mains socket.
This appliance is wired as follows:
• Live wire (coloured brown) to terminal marked L
• Neutral wire (coloured blue) to terminal marked N
• Earth wire (coloured green/yellow) to terminal marked E
This appliance must be earthed, using a dedicated earthing circuit.
If in doubt consult a qualified electrician.
Electrical isolation points must be kept clear of any obstructions. In the event of any emergency
disconnection being required they must be readily accessible.
Fault Probable Cause Action
The appliance is not working The appliance is not switched on Check the appliance is plugged in correctly
and switched on
Plug and lead are damaged Call Apuro agent or qualified technician
Fuse in the plug has blown Replace the plug fuse
Power supply Check power supply
Internal wiring fault Call Apuro agent or qualified technician
Heating element has expired Call Apuro agent or qualified technician
Model Voltage Power Current
Cooking
Surface
Diameter
Temperature
Range
Dimensions
h x w x d (mm) Weight
CC039-A 230V 50Hz 2900W 12.6A 410mm 60-300ºC 140 X 550 X 456 17.6kg

4
Telephone Helpline: 130 0225960)
Compliance
The WEEE logo on this product or its documentation indicates that the product must
not be disposed of as household waste. To help prevent possible harm to human
health and/or the environment, the product must be disposed of in an approved and
environmentally safe recycling process. For further information on how to dispose of
this product correctly, contact the product supplier, or the local authority responsible
for waste disposal in your area.
Apuro parts have undergone strict product testing in order to comply with regulatory
standards and specifications set by international, independent, and federal
authorities.
Apuro products have been approved to carry the following symbol:
All rights reserved. No part of these instructions may be produced or transmitted in any form or by any means, electronic,
mechanical, photocopying, recording or otherwise, without the prior written permission of Apuro.
Every effort is made to ensure all details are correct at the time of going to press, however, Apuro reserve the right to change
specifications without notice.

5
Telephone Helpline: 130 0225960)
NOTES

DECLARATION OF CONFORMITY
I, the undersigned, hereby declare that the equipment specified above conforms to the
above Legislation and Standard(s).
Equipment Type Crepe Maker
Model CC039-A
Legislation C-Tick
AS/NZ 3820 Essential Safety Requirements for Low Voltage
Electrical Equipment
Standards EN 55014-1:2006+A1: 2009+A2: 2001
EN 61000-3-2: 2006+A1:2009+A2:2009
EN 61000-3-3:2008
EN 55014-2:1997+A1: 2001+A2: 2008
EN 60335-2-38:2003+A1:2008
EN 60335-1:2002+A11:2004+A1:2004+A12:2006+A2:2006
EN 50366:2003+A1:2006
Producer Name Apuro
Producer Address 15 Badgally Road,
Campbelltown,
NSW 2560
Date 05/09/14
Signature
Full Name Richard Cromwell
Position Commercial Director

CC039-A_A5_v2