Aqara Wireless Mini Switch User manual

Wireless Mini Switch

English
Wireless Mini Switch Quick Start Guide
Product Introduction
Aqara Wireless Mini Switch is a remote control switch with
compact design and low energy consumption. You can
place or stick it almost anywhere. Single press, double
press or long press to control various smart accessories,
such as, Smart Light and Smart Plug.
* A hub is required.
* Aqara Hub is required to enable Aqara Wireless Mini Switch to work
with HomeKit technology. See www.aqara.com for more details.
* This product is for indoor use only.
Indicator Light
Push Button
Reset Button
Long Press for 3s: Reset/Connect to
Network
Single Press: Eective Range Test

English
1. Before activating the accessory, please make sure you have
the Aqara Home app downloaded and Aqara hub installed.
Quick Setup
2. Please open the app, tap“Home”and then tap“+”in the top
right corner to enter“Add Device (Accessory)”page. Select
“Wireless Mini Switch”, and add it according to instructions.
*If the connection fails, please move the accessory closer to the Hub and
try again.
Eective Range Test: Single press the reset button on the
accessory at your desired position. If the Hub makes voice
prompts, it indicates that the accessory can communicate
eectively with the Hub.
* Avoid metal surface to maximize signal strength.
Installation
Option 1: Place it directly in the desired position.

English
Option 2: Remove the protective lm, and stick it to the
desired position.
* Keep the surface clean and dry.
Online Customer Service: www.aqara.com/support
Email: [email protected]
Manufacturer: Lumi United Technology Co., Ltd.
Address: 8th Floor, JinQi Wisdom Valley, No.1 Tangling Road, Liuxian
Ave,Taoyuan Residential District, Nanshan District, Shenzhen, China.
Model: WXKG11LM
Dimensions: 45 × 45 × 12 mm (1.77 × 1.77 × 0.47 in.)
Wireless Protocol: Zigbee
Battery: CR2032
Operating Temperature: -10°C – +50°C (14°F – 122°F)
Operating Humidity: 0 – 95% RH, no condensation
Maximum Transmit Power (Zigbee): 9.99 dBm
Working Frequency: 2400 MHz – 2483.5 MHz
Specications

English
1.
2.
3.
4.
5.
This product is NOT a toy. Please keep children away from
this product.
This product is designed for indoor use only. Do NOT use in
humid environments or outdoors.
Beware of moisture, do NOT spill water or other liquids
onto the product.
Do NOT place this product near a heat source. Do NOT
place it in an enclosure unless there is normal ventilation.
Do NOT attempt to repair this product by yourself. All
repairs should be performed by an authorized professional.
Warnings
This product is only suitable for improving the
entertainment, convenience of your home life and
reminding you about the device status. If a user violates
the product use instructions, the manufacturer will NOT be
liable for any risks and property losses.
6.
FCC ID: 2AKIT-WXKG11LM
Federal Communications Commission (FCC) compliance statement:
1. This device complies with part 15 of the FCC Rules.

communications. However, there is no guarantee that interference will
not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be
determined by turning the equipment o and on, the user is
encouraged to try to correct the interference by one or more of the
following measures:
-Reorient or relocate the receiving antenna.
-Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit dierent from that
English
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) this device must accept any interference received, including
interference that may cause undesired operation.
2. Changes or modications not expressly approved by the
party responsible for compliance could void the user's
authority to operate the equipment.
Note: This equipment has been tested and found to comply with
the limits for a Class B digital device, pursuant to part 15 of the FCC
Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio

English
to which the receiver is connected.
-Consult the dealer or an experienced radio/TV technician for help.
RF Exposure statement:
This equipment complies with FCC radiation exposure limits set forth
for an uncontrolled environment. This equipment should be installed
and operated with minimum distance of 20 cm between the radiator
and your body.This transmitter must not be co-located or operating in
conjunction with any other antenna or transmitter.
IC: 22635-WXKG11LM
IC NOTICE TO CANADIAN USERS
This device contains licence-exempt transmitter(s)/receiver(s) that
comply with Innovation, Science and Economic Development Canada’s
licence-exempt RSS(s). Operation is subject to the following two
conditions:
(1) This device may not cause interference.
(2) this device must accept any interference , including
interference that may cause undesired operation. of the device.
This Class B digital apparatus complies with Canadian ICES‐003.
This device complies with RSS‐247 of Industry Canada. Operation is
subject to the condition that this device does not cause harmful
interference.
This equipment complies with IC radiation exposure limits set forth for
an uncontrolled environment.This equipment should be installed and
operated with minimum distance of 20 cm between the radiator and