Aqua Creek F-105LAR User manual

Copyright © 2016 Aqua Creek Products All Rights Reserved Revised 12/13/16
Pull-Out Legrest
Instructions
9889 Garrymore Ln
Missoula, MT 59808
888-687-3552 | [phone]
www.aquacreek.com
PART #: F-105LAR
MANDATORY
LEAVE THIS MANUAL WITH LIFT OWNER
Read and follow all instructions.
Lift safety can only be ensured if the lift is installed and
operated according to these instructions.
• NEVER permit children to play on or around the lift
• Do not allow children to use the lift without adult
supervision
• NEVER apply direct water pressure to the electronics
• NEVER use the lift with a dry pool
Check entire box and all packing materials for parts. Before beginning assembly, read the
instructionsandidentifypartsusingtheguresandpartslistedinthisdocument.
It is critical that all parts be carefully inspected prior to installation. If any damage occurred in
transit,AquaCreekProducts,LLCmustbenotiedwithinthreedaysofreceiptofunit.
Proper installation cannot be overstressed, as an improper installation voids Aqua Creek’s
warranty and may affect the safety of the user.
READ CAREFULLY
1

Copyright © 2016 Aqua Creek Products All Rights Reserved Revised 12/13/16
The PULL-OUT LEGREST ASSEMBLY is designed to t under the standard Aqua Creek chair, and is
installed inside the 2”square tubing that supports the chair from underneath. To install the pull-out
leg-rest;
1. With a at-blade screwdriver, pry o the 2” square plug from the end of the 2”square tube of the
seat arm.
2. Drill a 9/32” hole at the location indicated in the drawing below through the bottom of the chair
support tube. Drill only through the bottom of the tube. Remove the burrs from the hole before
installing the legrest assembly.
Installation Instructions:
2" SQUARE
PLUG
SEAT ARM
SEAT
3/4"
1"
DRILL
9/32"
(THIS SIDE)
CHAIR SUPPORT TUBE
(BOTTOM VIEW)
DRILL
9/32" HOLE
(BOTTOM OF CHAIR SUPPORT TUBE)
(SEE DRAWING TO THE RIGHT)
2

Copyright © 2016 Aqua Creek Products All Rights Reserved Revised 12/13/16
3. Orient the pull-out legrest as shown below and slide the PLASTIC GUIDE/SPACER into the chair
support tube. Tap the PLASTIC GUIDE/SPACER with a hammer or mallet until ush with the end
of the support tube. The threaded hole in the bottom of the PLASTIC GUIDE/SPACER should line-up
with the hole drilled in STEP 2. Install the lock washer and 1/4 -20 x 1/2”cap screw from underneath and
tighten until snug.
PLASTIC GUIDE/SPACER
PULL-OUT LEGREST
1/4-20 X 1/2" CAP SCREW, SS
1" SQ. TUBE
1/4" LOCK WASHER, SS
CHAIR SUPPORT TUBE
PLASTIC GUIDE/SPACER
FLUSH WITH 2" SQ. TUBE
The PULL-OUT LEGREST is now ready to use. However, before using, slide the legrest in and out, and put
the pad up and down to make sure everything works smoothly.
LEGREST STOWED
PULL LEGREST OUT
FLIP LEGREST UP AND PIN
SLIDE FORWARD AND INSERT PIN TO LOCK IN "UP" POSITION
SLOT PIN
3