READ ALL INSTRUCTIONS BEFORE USE AND
SAVE THEM FOR FUTURE REFERENCE
WARNING
This product is intended to filter tap water only. Do not put
water of unknown quality or that has been microbiologically
contaminated into the product.
BEFORE USING THE FILTER JUG FOR THE FIRST TIME
1. Remove all packaging from the jug.
2. Remove the lid from the jug and wipe it with a clean
damp cloth.
3. Remove the inner vessel and wash it thoroughly.
PREPARING THE WATER FILTER CARTRIDGE
1. Remove all packaging from the filter cartridge. There may
be a small residue of black carbon particles in the bag
or on the surface of the cartridge; this is normal. These
particles are harmless and are washed o during the
preparation process.
2. Soak the cartridge in a bowl of water
for 5–10 minutes to remove all the air
bubbles.
3. Rinse for 1 minute under a running tap.
4. The filter cartridge is now ready for use.
FITTING THE FILTER INTO THE INNER
VESSEL
1. Fit the Aqua Optima filter cartridge into
the underside of the inner vessel and
rotate clockwise to lock into place.
Ensure that it is firmly secured.
2. Place the inner vessel back into the filter
jug ensuring the flat edge of the inner
vessel is facing towards the front of the jug.
3. Refit the lid.
4. Fill the inner vessel with cool water and
let it pass through the filter. Once it has
been filtered, discard the water. Repeat
the procedure once more.
5. Fill the inner vessel for a third time, your
water filter jug is now ready for use.
FILTER CARTRIDGE LIFE INDICATOR
The filter cartridge life indicator on the lid
will remind you when to change the filter
cartridge and ensure optimum performance.
AQUA OPTIMA 30-DAY FILTER CARTRIDGE
To ensure the best performance, the filter cartridge should
be changed after 100 litres, which is approximately 4 weeks
of typical use.
After you have fitted the filter cartridge set the indicator dial
to the next month (approx. 4 weeks). For example if it is April
– month 4 – then set the dial to month 5 – May.
AQUA OPTIMA 60-DAY FILTER CARTRIDGE
To ensure the best performance, the filter cartridge should
be changed after 200 litres, which is approximately 8 weeks
of typical use.
After you have fitted the filter cartridge set the indicator dial
two months ahead (approx. 8 weeks). For example if it is
April – month 4 – then set the dial to month 6 – June.
Every time you replace the cartridge, reset the indicator
again following the above instructions.
REPLACING THE FILTER CARTRIDGE
• Remove the lid and lift out the inner vessel.
• Hold the inner vessel and rotate the cartridge
anticlockwise to release it.
• Prepare and insert the new cartridge as described above.
FOR BEST RESULTS
• To prevent the filter from drying out, it should not be left
unused for long periods. If such an extended period is
anticipated (such as a holiday), then it is best to remove
the filter and store it in a sealed plastic bag. The filter
can then simply be prepared as per the original fitting
instructions. Refer to Preparing the water filter cartridge
above.
• Store the filter jug in the refrigerator or in a cool place.
It is important to store the jug out of direct sunlight and
away from heat sources.
• If the filtered water is not used within 48 hours, pour the
water away and re-fill the jug with fresh water.
• Wash and rinse the inner vessel and jug regularly. The lid
should be wiped clean with a damp cloth.
• Use only cold or room temperature water for filtering.
• Only use mild cleaning agents, never solvents or corrosive
chemicals. Never use abrasive pads on this product.
• Do not use the filter jug for any other purpose than for
filtering water.
EN
Easy fill
pour through lid
Filter cartridge
life indicator
Inner vessel
Filter
cartridge
Spout
Jug
1 Min
PRE_857 Rev1 10/15
