Aquasana AQ-4050 User manual

Aquasana AQ-4050/AQ-4055
Under-sink Adapter Kits
(for use with the Aquasana AQ-4000
This product can be used only with the supplied faucet
and is not designed to be used in constant pressure
applications, such as ice makers or fountains.
PLEASE NOTE: For the first 72 hours of use you may
notice a slight drip. This is normal and will cease with
use of your new AQ 4000.
With Aquasana, you can bottle your own!
aquasana.com
ONCE THE FILTER AND FAUCET ARE MOUNTED and the brass
"T" supply valve is properly attached to the cold water supply
line proceed with the following steps:
A. Connect the hoses as shown in figure A or B.
B. Turn the cold water supply line on this will open the water
supply to the faucet.
C. Check for leaks. If leaks are present, turn off the supply valve
and check all connections.
D. Lift the black lever on the filter faucet as shown below and
allow the water to run until all cloudiness and air bubbles are
gone. this faucet lever can be pushed down for water on
demand or lifted to the upright position for continuous flow.
E. DRINK AND ENJOY!

PRECAUTIONS:
• Read all instructions carefully
• No constant hydrostatic
pressure line to filter allowed.
• Use teflon tape only. Do not
use plumber's putty.
• For technical support call:
866-2DRINK8
UNPACK THE CONTENTS of the
Under-sink adapter kit and
determine the appropriate location
for the faucet to be mounted. The
faucet may be mounted using an
existing hole for a sprayer nozzle or
other accessory, or by drilling a 7/8˝
hole in the sink or counter-top. We
do not recommend drilling granite
or porcelain sinks unless done by a
professional. Be sure the location of
the faucet allows the outlet spout
to extend slightly past the edge of
the sink.*
*All of our faucets have a 4˝ overhang
CONTENTS LIST
Open Relief faucet
Mounting Bracket
Screws and Anchors
1/2˝ Plumbing Tee
3/8˝ Plumbing Tee
MOUNT THE FAUCET AS
SHOWN in diagrams A & B.
Mount the filter unit using
the white steel mounting
bracket and screws in figure below.
Make sure that the location of the
filter unit allows the tubing from
the faucet to connect to the base
of the filter without kinking or side
pressure; if the hose is not able to
plug straight into the inlet without
side pressure, it may drip.
TURN OFF YOUR COLD WATER
SUPPLY VALVE and attach
the "T" valve fitting to the cold
water supply line as shown in
figure A or B.
If your cold water supply line is not
a standard line, and does not allow
use of the supplied "T" fittings ,
you will need to purchase a "T'
adapter or saddle valve from your
local hardware or plumbing supply
store. It will need to have a 1/4˝
compression outlet from the "T".
FIGURE A
FIGURE B
Brass "T" fitting
PVC "T" fitting
AB
AB