Aquasana AQ-5300A User manual

Installation Instructions
AQ-5300A Under Counter Water Filter
Welcome to the Aquasana experience. You are about to enjoy clean, healthy water and the
peace of mind that comes from knowing award-winning filter technology is working for you.
Installation must comply with state and local laws.

The AQ-5300A comes with a chrome designer faucet finish
The faucet may be mounted on the sink using an existing hole for a sprayer nozzle or
soap dispenser, or by drilling a hole at least 1/2” in diameter. Be sure the location of the
faucet allows the spout to extend slightly past the edge of the sink. Note: we recommend
enlisting the services of an approved or certified professional if drilling is required.
AAQ-5300 filter unit
BFaucet (1)
CFilter Cartridges (3)
DScrews with anchors (2)
EFaucet Rubber Washer (1)
FFaucet Spacer (1)
GFaucet Washer (1)
HFaucet Nut (1)
IBattery (1)
JChrome nut (1)
KPlastic collar (2)
LPlastic tube insert (1)
M Brass nut (1)
N Brass tube insert (1)
OBrass Tee (1)
PPoly Tubing (Not Shown)
Preparing for Installation
Please read entire installation guide before installing the filter system.
Tools Recommended for Installation
• Variable speed drill + 7/32” bit
• Adjustable wrench
• Measuring tape
• Bucket
• Phillips head screwdriver
• Hammer
Before beginning installation, please ensure
all parts listed are present. If any part is
missing or damaged, do not attempt to install
the filter.
Estimated Installation Time: 45 minutes
A
B
C
D
E
H
L
F
I
M
G
J
N
K
O

Easy to install
Unpack and unwrap contents. Turn o and
disconnect the cold water supply.
Select a space under your sink for the
filter unit that is at least 12 in. from the
bottom of your cabinet to allow easy access to
the water and for filter replacements. Use the
mounting holes located at the back of the unit to
mark the wall screw placements. Hole distance:
.”
Attach each sump to the bottom of the unit
housing. Align connection points, push the sump up
and turn to the right. Ensure that the sump is locked in.
Turn the cold water on. Check for
leaks and proper installation: place a
towel under the filter unit and check for leaks.
Allow water to run for 10 minutes to flush
carbon fines. Note: Never use oils to lubricate
the O-rings; O-rings come pre-lubricated.
Attach white tube to the brass tee: Slide the compression nut onto the
white tubing (with threads of the nut facing the end of the white tube).
Next, slide the plastic sleeve onto the white tube. Place brass insert into the
opening of white tube. Push the tip of the white tubing into the opening
of the brass tee. While holding the white tube in place inside the brass tee,
tighten the compression nut to compress the plastic sleeve and create a seal.
NOTE: Use a wrench to ensure complete seal. Avoid over tightening.
Connect supply lines: insert tubing from
the tee fitting into the inlet side and
insert tubing from the faucet into the outlet
side. Use diagram on the right to mark tubing
depth to ensure they get inserted completely.
It is VERY IMPORTANT to insert tubing
completely so leaking does not occur.
Faucet
Installation:
Install as shown.
Tighten nut to secure
faucet to sink.
Use a 7/32” drill bit to drill holes.
Carefully tap the plastic anchors into the
drilled hole with a hammer. Mount unit to
the wall with the screws. Pull the protective
plastic strip from the battery compartment.
The red LED should flash and beep five (5) times
to indicate that the battery is installed correctly.
Attach threaded ends of supplied brass tee
to the cold water supply line and shut-o
valve; tighten using an adjustable wrench.
Faucet Connection: connect the outlet hose to the
base of the faucet by sliding the chrome nut onto the
tube followed by the white collar. Place the white insert into
the end of the tube. Press the tube against the faucet base
and slide the nut and collar up to the threads. Use wrench
to ensure seal is suciently tight.
Note: Avoid over tightening.
2
1
E
H
N
F
M
G
K

K
L
J
P
P
1
INCH
CM 2 3 4 5 6
7 8
25mm
.98”
1 2
3
Depth to insert tubing (actual size)
A

AQ-5300A
Replacement cartridge:
AQ-5300AR
Rated service flow:
1.3 gpm (4.91 liters)
Max capacity:
1,095 gal (4,145 liters)
Min working pressure:
20 psi (1.4 kg/cm2)
Max working pressure:
80 psi (5.62 kg/cm2)
Min operating temp.:
40 F (4.44 C)
Max operating temp:
90 F (32.22 C)
Do not use with water that is microbiologically unsafe or of
unknown water quality without adequate disinfection before or
after the system. Systems certified for cyst reduction may be used
on disinfected waters that may contain filterable cysts.
Care and Maintenance
To clean your filter unit, wipe down the exterior with a
damp cloth.
Once filters are at 95% capacity (about every 6 months),
the battery alarm will sound and flash red when water
is flowing and will continue for 15 seconds once water is
turned o. Change the battery every time you replace
your filters. The battery is included with the filter
replacement cartridges.
Pure Satisfaction
All Aquasana products oer a 90-day 100% satisfaction
guarantee. (A 1-year warranty is included, which covers
defects in materials and workmanship.) If for any reason
you are not satisfied with your purchase, simply call us or
the dealer you purchased from. A Return Authorization
Code and a full refund will be promptly issued upon return.
Thank you for choosing Aquasana!
This filter system is designed and tested for use with
genuine Aquasana parts, including replacement filters and
all hardware except for the actual faucet. Use of parts from
other manufacturers may result in loss of contaminant
reduction performance, system damage or failure. Use of
parts from other manufacturers (besides the faucet) will
also void your warranty. Please visit www.aquasana.com
for all replacement parts.
WARNING
Do not use tools to remove or
tighten sumps. Over tightening can
cause damage and result in leaking.
Hand tighten only.
Remove each
sump from
the manifold
by hand.
Place
wrench
over sump top
and slide down.
Turn wrench
counterclockwise.
Continue turning
counterclockwise.
Remove top
and filter.
Undercounter Wrench
Precautions:
• Slow Filter? change pre-filter cartridge more often.
• Filter is only to be used with cold water.
• If you experience a leak at the hose connection, disconnect and re-seat the hose.
• Aquasana is not liable for consequential or incidental damages due to
improper installation.

Aquasana, Inc.
6310 Midway Road
Haltom City, Texas 76117
866.662.6885 USA
877.332.7873 Canada
www.aquasana.com
For exclusive deals
facebook.com/aquasana
twitter.com/aquasana
System tested and certified by NSF
International against NSF/ANSI Standard
42, 53 & 401 for the reduction of the
claims specified on the Performance Data
Sheet and at www.nsf.org.