Argos Home hygena Matrix Round Glass Lamp Table User manual

Assembly Instructions - Please keep for future reference
Dimensions
Width - 40cm
Depth - 40cm
Height - 45.6cm
Important - Please read these instructions fully before starting assembly
If you need help or have damaged or missing parts, call the Customer Helpline: 08456 400800
Glass Round Lamp Table
issue 1 4/16/10
609/1415

We do not
recommend the use
of power drill/ drivers
for inserting screws,
as this could damage
the unit. Only use hand
screwdrivers.
Warning: The unit weighs
approximately 3.9kgs.
Please lift with care.
1
Safety and Care Advice
Important - Please read these instructions fully before starting assembly
Check you have all the
components and tools listed on
pages 2 and 3.
plastic bags and separate them
into their groups.
Remove all fittings from the
Keep children and animals
away from the work area, small
parts could choke if swallowed.
Make sure you have enough
space to layout the parts before
starting.
Do not stand on the panels, this
could cause damage.
Assemble the unit as close to its
final position (in the same room)
as possible.
Assemble on a soft level
surface to avoid damaging the unit
or your floor.
Parts of the assembly will be
easier with 2 people.
Dispose of all packaging carefully
and responsibly.
●Only clean using a damp cloth
and mild detergent, do no use
bleach or abrasive cleaners.
●From time to time check that
there are no loose screws on this
unit.
●This product should not be
discarded with household waste.
Take to your local authority waste
disposal centre.
Care and maintenance
disposal centre.
Assembly to be carried out by
the competent adult only.
During assembly children
should be kept away from the
product due to the potential risk of
injury.
Do not use this item if any
components are missing or
damaged.
Keep these instructions for future reference
If a glass component is chipped
or broken, stop using the product
and consult the manufacturer
supplier.
This product complies with
BSEN14749.
Argos Ltd. MK9 2NW.
Warning
Do not place very hot or very
cold items against or in close
proximity to glass surfaces unless
an adequately thick insulating
material is used to prevent such
items from coming into contact
with the glass.
Do not strike the glass with hard
or pointed items.
When cleaning glass panels
use a damp cloth or leather with
washing up liquid or soft soap if
necessary; do not use washing
powders or any other substances
containing abrasives since these
substances scratch glass.

Components - Panels
Please check you have all the panels listed below
2
Top glass x 1 (40 x 40cm)
1Base glass x 1 (35 x 35cm)
2
Tube x 1 (5 x 42cm)
3
If you have damaged or missing components,
call the Customer Helpline:08456 400800
Two end threaded bolt x 2
Components - Fittings
Please check you have all the fittings listed below
Ruler - Use this ruler to help correctly identify the screws
A
Note: The quantities below are the correct amount to complete the assembly. In some cases more fittings
may be supplied than are required.
0 5 10 15 20 25 30 35 40 45 50 55 60 65 70 75 80 85 90 95 100 105 110 115 120 125 130 135 140 145 150 155 160 165 170
B
Glass pad x 5

Assembly Instructions
Step 1
Fitting the tube
a:
Step 1
b:
B
2
3
c: Screw in Tube
onto the unit.
3
Note: Assemble on a soft
level surface or on the
original packing material to
avoid damaging the unit or
your floor.
3
c:
b: Screw in Two end
threaded bolt onto
Base glass .
A
2
A
2
a: Stick the Glass pads
c onto the Base glass
c .
B
2
2

Assembly Instructions
Step 2
Fitting the top
a:
Note: It would be useful to
ask someone to help you
at this stage.
b:
Assembly is complete.
If you need help or have damaged or missing parts, call the Customer Helpline : 08456 400800
4
b: Screw in Top glass
onto the unit.
1
1
a: Screw in Two end
threaded bolt onto
Top glass .
A
1
A
1