ARMORDILLO 8702635 User manual

RS Running Boards
2019-2022 Ram 1500 - Crew Cab
(Excl 2019-2022 Ram 1500 Classic)
Page 1 of 4 8/4/20 (AL)
ARMORDILLO Products are designed as decorative accessories and should not be relied upon as protection for the vehicle or passengers.
Buyers assume all risk and liability whatsoever resulting from installation and use of products. We assumes no liability for injury, loss,
incidental or consequential damages in the event of an accident.
ARMORDILLO guarantees the original purchaser a LIMITED 3-YEAR WARRANTY from data of purchase against manufactured defects in
materials, workmanship and finish under normal use. This excludes damage resulting from road hazards, debris, product misuse, improper
installation, impairments from accidents, neglect, shipping or product modification. This warranty applies only to new products and is
limited to the repair or replacement products. Warranty does not included cost of removal, installation, labor, freight, inconvenience, or
consequential damage. Original purchaser must return defective merchandise to the original place of purchase and must provide the proof
of purchase.
WARNING: When working on ,under or around vehicle exercise caution. If working without a lift check vehicle owners manual for correct
jacking points. Always wear safety glasses and ensure a safe working area. Serious injury or death could occur if safety measures are not
followed.
ARMORDILLO RECOMMENDS PROFESSIONAL INSTALLATION ON ALL THEIR PRODUCTSSTOP - Verify part and application is correct
before proceeding. If missing part or damage item please contact customer service directly via message system on the site you bought the
item from.
Call us at [phone] Monday-Friday 9am-6pm PST
Email us At [e-mail]

RS Running Boards
2019-2022 Ram 1500 - Crew Cab
(Excl 2019-2022 Ram 1500 Classic)
Page 2 of 4 8/4/20 (AL)
PARTS LIST:
1
Driver/Left RS2 Running Board
24
10mm x 27mm OD x 3mm Flat Washers
1
Passenger/Right RS2 Running Board
12
10mm Nylon lock Nuts
6
Mounting Brackets
18
8mm x 24mm OD x 2mm Flat Washers
12
10-1.5mm x 35mm Hex Bolts
18
8mm Nylon Lock Nuts
PROCEDURE: REMOVE CONTENTS FROM BOX. VERIFY ALL PARTS ARE PRESENT. READ
INSTRUCTIONS CAREFULLY BEFORE STARTING INSTALLATION. ASSISTANCE IS RECOMMENDED.
1. Start the installation under the Passenger/Right side of the vehicle. Locate the front (3) factory studs
along the inner side of the body panel, (Figure 1). NOTE: Use a wire brush or die to remove paint
buildup on the threaded studs.
2. Select (1) Mounting Bracket. Attach the Mounting Bracket to the (3) factory studs with (3) 8mm Flat
Washers and (3) 8mm Nylon Lock Nuts, (Figures 2 & 3). Leave brackets loose at this time.
3. Repeat Steps 1—3 to attach and (2) Mounting Brackets to the center and rear mounting locations
along the body panel, (Figures 4—7).
4. Select the Passenger/Right RS2 Running Board. With assistance, attach the Running Board to the rear
faces of the Mounting Brackets with (6) 10mm x 35mm Hex Bolts, (12) 10mm Flat Washers and (6)
10mm Nylon Lock Nuts, (Figure 8).
5. Level and adjust the Running Board as necessary and fully tighten all hardware.
6. Repeat Steps 1—5 to attach the Driver/Left RS2 Running Board.
7. (OPTIONAL) If treads on the stepping platform are desired, remove the platforms from both Running
Boards and reattach them to the opposite sides, (Figure 9).
8. Do periodic inspections to the installation to make sure that all hardware is secure and tight.
To protect your investment, Do not use any type of polish or wax that may contain abrasives that could damage the
finish. Mild soap may be used also to clean the Running Board.
(6) Mounting Brackets
Passenger/Right RS2
Running Board
Front

RS Running Boards
2019-2022 Ram 1500 - Crew Cab
(Excl 2019-2022 Ram 1500 Classic)
Page 3 of 4 8/4/20 (AL)
Passenger/Right Side Installation Pictured
(3) 8mm Flat Washers
(3) 8mm Nylon Lock Nuts
(Fig 2) Attach (1) Front/Rear Mounting
Bracket to the (3) studs
Front
Front
(Fig 1) Passenger/Right front mounting location
(Fig 4) Passenger/Right center mounting location
(Fig 3) Front/Rear Mounting Bracket
attached to the front location
Front

RS Running Boards
2019-2022 Ram 1500 - Crew Cab
(Excl 2019-2022 Ram 1500 Classic)
Page 4 of 4 8/4/20 (AL)
Passenger/Right Side Installation Pictured
(Fig 8) Attach the Running Board to the
rear faces of the Mounting Brackets
(Fig 6) Passenger/Right rear mounting location
Rear
Front
(Fig 5) Passenger/Right Center Mounting
Bracket attached to the center location
(Fig 7) Front/Rear Mounting Bracket
attached to the rear location
(2) 10mm Hex Bolts
(4) 10mm Flat Washers
(2) 10mm Nylon Lock Nuts
Rear
Front
(Fig 9) (Optional) Remove the platform on both
Running Boards to switch the boards for
treads on top of the platforms for less slipping