SDWP-001
Electronic touch panel cabinet lock
User manual
●
DIGIT PANEL:
Touch digits panel to activate the system.
●
Default code:
For 8-digit management: 12345678
For 6-digit user: 123456.
●
Security alarm:
If entering wrong code 3 times, digit panel will flash with alarm sound
“beep beep beep” for 30 seconds. You are not able to enter any digit at this
moment until alarm off.
SET UP AUTO / MANUAL CLOSE MODE
The lock is set to auto-close mode initially.
To switch the auto / manual mode, press the
button A at back of the lock.
●
Auto-close mode (“ Beep beep” sound):
The plunger will come out after 8 second.
●
Manual-close mode (“Beep” sound):
An user has to enter 6-digit user code, then the plunger will come out.
Modify code:
●
Change user’s code
After open the lock with user code Press “set” Enter “new 6 digit code” Press “OK”
Plunger will come out if code Press “OK” button again Enter “6-digit” code again
•changes successfully
●
Change management’s code
After open the lock with management’s code Press “set” Enter “new 8 digit code”
Press “OK” button again Enter “8-digit” code again Press “ OK” button
Plunger will come out if code changes successfully
**User code will default to 123456 after using management code to unlock
Lock and unlock (Under manual-close mode ):
●
To unlock
Enter 6 digit code Press “OK” button The plunger goes in to “Unlock”
●
To lock
Enter 6 digit code Press “OK” button The plunger comes out to “Lock”
**When entering wrong code, press “SET” to erase and re-enter user code
Lock and unlock (Under auto-close mode ):
Using user 6-digit code
●
To unlock and lock
Touch digit panel to activate system Press 2 random digits Press user 6-digit code
•Press “OK” button again to lock Press “OK” button to unlock
After 6 seconds, the plunger will come out automatically
Using management 8-digit code
●
To unlock and lock
Touch digit panel to activate system Press 2 random digits Press admin 8-digit code
•Press “OK” button again to lock Press “OK” button to unlock
After 6 seconds, the plunger will come out automatically
**When enter admin 8-digit code to open lock, the user’s 6-digit code will default to 123456
Reset
Press button “B” to reset system. Management code will
default to 12345678 and user code will default to
123456
