CÓMO USAR
4
HOW TO USE
Simplify your life with hot water at the touch of a button. Whether heating water
for your baby’s formula or for instant soup, the Aroma Hot H2O X-Press is the
perfect addition to the busy household!
Ideal for:
Instant hot chocolate, coffee, and other powdered beverages
Instant soups, oatmeal, and “just add water” packaged food
Baby formula (be sure to add a mixture of cold and hot water as water from
Aroma Hot H2O X-Press will be very hot).
Before First Use:
1. Read all the instructions and important safeguards.
2. Remove all packaging materials; make sure all your items are received in good
condition.
3. Wash the inside pot with warm soapy water using a sponge or dishcloth.
4. Rinse thoroughly to remove soapy residue.
5. Wipe body clean with a damp cloth.
Do not use abrasive cleaners or scouring pads.
Do not immerse the appliance, cord or plug in water at any time.
To Heat Water:
1. Lift the top lid handle to open the lid. If needed for filling purposes, the entire lid can
be removed from the load/unload hinge on the back of lid.
2. Fill the pot with water anywhere between the “Full” mark and the “Refill” mark,
depending on desired quantity. Properly replace before using Hot H2O X-Press.
3. Attach power cord to Hot H2O X-Press by plugging connector to main body and then
connecting the plug to wall outlet.
4. The “Heat” indicator light will illuminate and the water will automatically begin heating.
5. Once the water has reached the boiling point, the “Heat” indicator light will go off and
the “Warm” indicator light will illuminate. The Hot H2O X-Press will remain in the
“Warm” function as long as it is plugged in.
4
WARNING:
• Never fill water more than the “FULL” mark or below the “REFILL” mark, otherwise
it will spill over or dry-up during boiling.
• Do not open the top lid when water is boiling to avoid scalding by hot steam.
• Be sure not to pour water out in the front of the panel or in the back of it.
Antes de usarlo por primera vez:
1. Lea todas las instrucciones y precauciones importantes.
2. Retire todos los materiales de embalaje; asegúrese de que todos los artículos
recibidos estén en buenas condiciones.
3. Lave el jarro interior con agua jabonosa tibia y una esponja o paño.
4. Enjuáguelo bien para eliminar todo resto de jabón.
5. Limpie el cuerpo con un paño húmedo.
No use limpiadores abrasivos ni estropajos.
No sumerja en agua el equipo, el cable ni el enchufe.
Para calentar agua:
1. Levante el asa de la tapa superior para abrirla. Si fuera necesario para poder llenarlo, se
puede desprender la tapa de la bisagra de carga/descarga en la parte posterior de la tapa.
2. Llene el jarro con agua hasta un nivel entre la marca "Full" (lleno) y "Refill" (volver
a llenar), según la cantidad que desee. Colóquela de nuevo antes de usar el
calentador.
3. Conecte el cable al calentador enchufando el conector al cuerpo principal y luego
conectando el enchufe en un tomacorriente.
4. La luz indicadora "Heat" (calentar) se encenderá y el agua comenzará a calentarse
automáticamente.
5. Una vez que el agua haya alcanzado el punto de ebullición, la luz indicadora "Heat"
(calentar) se apagará y se encenderá la luz indicadora "Warm" (mantener caliente). El
calentador permanecerá en la función "Mantener caliente" mientras esté enchufado.
Para servir agua:
1. Para servir agua automáticamente, oprima el botón "Automatic Dispenser"
(dispensador automático) y saldrá el agua. Si suelta el botón, dejará de salir el agua.
2. Para servir agua con la bomba manual, deslice el cierre de seguridad en la parte
superior de la tapa a la posición
"On" (encendido) y oprima la
bomba de presión. Al oprimir saldrá
agua. Repita hasta haber servido la
cantidad de agua deseada.
3. Para servir usando el interruptor, empuje
hacia arriba el activador ubicado detrás
del pico vertedor y comenzará a salir
agua. Cuando la taza esté llena, retírela
y el agua dejará de salir.
ADVERTENCIA:
• No permita que el agua sobrepase la marca "FULL" ni que quede debajo de la
marca "REFILL"; de hacerlo, el agua se rebasará o se secará al hervir.
• No abra la tapa superior cuando el agua esté hirviendo para evitar quemarse con el
vapor caliente.
• Asegúrese de no echar agua por fuera, ni delante ni detrás del panel.