Artesyn ATCA-9305 User manual

ATCA-9305
Quick Start Guide
P/N:6806800L91B (May 2014)
Observe ESD-safe
measures
What’s in the box?
When installing or servicing the
module or accessories, strictly
observe the safety precautions in
the Safety Notes. Otherwise, per-
sonal injury or property damage
may occur.
• Use either a properly grounded ESD wrist
strap or make sure that you are working
in an ESD-safe environment.
• Connect to the ESD connector at the
front or the rear of the system.
Make sure you receive all items of your
shipment:
• ATCA-9305 blade
• Other items that were ordered
• Printed Safety Notes
Prepare the installation
site
• For information on the environmental
and power requirements, see the ATCA-
9305 Installation and Use manual.
• Operating temperatures refer to the
temperature of the air circulating around
the blade and not to the actual compo-
nent temperature.
1
2
3

ATCA-9305-Quick Start Guide
Artesyn Embedded Technologies
Marketing Communications
2900 S. Diablo Way, Suite 190
Tempe, Arizona 85282
Artesyn Embedded Technologies
Lilienthalstr. 17-19
85579 Neubiberg/Munich
Germany
Install the blade
The following procedure assumes that
your system is powered. If your system
is unpowered, you can disregard the
blue LED and skip the respective steps.
1. Ensure that the top and bottom ejec-
tor handles are in the outward posi-
tion by squeezing the lever and the
latch together.
2. Insert the blade into the shelf by
placing the top and bottom edges of
the blade in the card guides of the
shelf. Ensure that the guiding mod-
ule of the shelf and blade are aligned
properly.
3. Apply equal and steady pressure to
the blade to carefully slide the blade
into the shelf until you feel resis-
tance. Continue to gently push the
blade until the blade connectors
engage.
4. Squeeze the lever and the latch
together and hook the lower and the
upper handle into the shelf rail
recesses.
4Install the blade (cont)
5. Fully insert the blade and lock it to the
shelf by squeezing the lever and the
latch together and turning the handles
towards the face plate.
If your shelf is powered, as soon as the
blade is connected to the backplane
power pins, the blue LED is illuminated.
When the blade is completely installed,
the blue LED starts to blink. This indi-
cates that the blade announces its
presence to the shelf management
controller.
Note: If an RTM is connected to the front
blade, make sure that the handles of
both the RTM and the front blade are
closed in order to power up the
blade’s payload.
6. Wait until the blue LED is switched off,
then tighten the face plate screws
which secure the blade to the shelf. The
switched off blue LED indicates that the
blade’s payload has been powered up
and that the blade is active.
7. If necessary, connect cables to the face
plate.
4Install the blade (cont.
Finding more information
For more information on the product, see
the ATCA-9305 Installation and Use and
other related documentation.
Visit our Web site http://www.arte-
syn.com/computing. Use SUPPORT>TECH-
NICAL DOCUMENTATION link to look for
technical documentation.
Technical Assistance
To request technical assistance, visit our
Web site http://www.artesyn.com