Artistic Licence moody z Series User manual

Artistic Licence
moody z series
The full User Guide can be downloaded via the QR code
moody z series Quick Start Guide Version 2-0
Quick Start Guide
The moody z series
ymoody z1
- Controls a single RGB zone of DMX or DALI
- Wheel controls zone 1 colour
- DMX uses 3 channels for colour
- DALI uses 3 groups for RGB
ymoody z3
- Controls 3 RGB zones of DMX or DALI
- Wheel controls zone 1 colour
- DMX uses 9 channels for colour
- DALI uses 9 groups (RGB X 3)
ymoody z10
- Controls 10 RGB zones of DMX or DALI
- Wheel controls zone 1 colour
- DMX uses 30 channels for colour
- DALI uses 30 consecutive short addresses (RGB X 10)

Operation (moody z series)
Programming (moody z series)
To enter programming mode, press and hold control for 3 seconds.
Step 1
moody’s indicator LED ashes red to acknowledge it has entered
colour programming mode, then shows the colour of the zone.
Step 2 - programme the colour (hue)
a) Wait 5 seconds; moody will start slowly cycling through the colour
palette. When you see the colour you want, briey press the
control.
N.B. During the programming process, the relevant lights will
change to show the e󰀨ect of your zone programming.
b) Alternatively, rotate the control clockwise or counter-clockwise to
move forwards or backwards through the colour palette. When
you see the colour you want, briey press the control.
From factory, all scene channels are programmed to cyan. At power on, moody will automatically
fade the master level to full over 5 seconds.
If lights are on, briey press the control: moody fades the master level to zero over 5 seconds.
If lights are o󰀨, briey press the control: moody fades the master level to full over 5 seconds.
Rotate control clockwise or counter-clockwise to change the colour of zone 1. The LED indictor
shows the master level (always 100%) and colour of zone 1.
To programme a scene: please see instructions below on how to set the intensity and colour
of each zone.

moody’s indicator LED ashes white to acknowledge it has entered
white level programming mode, then displays the white level of the
zone.
Step 3 - programme the white level
Programming of zone 1 is now complete. moody’s indicator
LED ashes red to acknowledge that it is ready to accept colour
programming for zone 2. Repeat steps 2 & 3 for each zone.
Step 4 - programme the other zones
moody displays the master level (100%) and colour of zone 1. It is
now in normal operating mode.
Step 6 (end)
When programming of all zones is complete, press and hold
the control for 3 seconds to exit programming mode. moody
acknowledges by ashing green.
Step 5 - exit programming mode
N.B. In moody z, the white level is really saturation - it controls
the amount of white that is mixed in with the colour and allows
shades to be created.
b) Alternatively, rotate the control clockwise or counter-clockwise
to increase or decrease the white level. When you see the white
level you want, briey press the control.
a) Wait 5 seconds; moody will start slowly cycling through the white
levels. When you see the white level you want, briey press the
control.

Due to our policy of continuing product improvement
specications are subject to change without notice
Artistic Licence
The Mould Making Workshop
Soby Mews
Bovey Tracey
TQ13 9JG
United Kingdom
Telephone [phone]
Email: [e-mail]
Web: www.ArtisticLicence.com
[e-mail]