5. Sit at the loom and adjust the angle of the loom and footrest
to suit. Lift the support braces up under the front cross rail and
tighten all knobs and bolts.
6. Store the Hex Key in the hole in the footrest so you can
retighten the bolts if required.
7. The Freedom Roller can be attached to back of the loom to
use when weaving thick rugs or for long warps.
Enjoy weaving on your Rigid heddle Loom!
RightLeft
1. Secure the footrest to both extender rails using the end
holes, with 32mm (1 ¼”) bolts and barrel nuts.
2. Attach this footrest assembly to one leg and one foot as
illustrated with 0mm (2”) bolts and barrel nuts and lightly
tighten with the Hex Key. Note the tapered leg fits snuggly into
the tapered rebate in the foot. Repeat for the other side.
3. Insert 4 mm (1 ¾”) bolts from the inside of your loom and
tap the head of the bolt flush against the loom side. Then
locate the loom and bolts into the slots in the legs and secure
with washers and knobs.
4. Note the support braces are left
and right. Check they are on the
correct side and then attach them
to the legs with mm (2 ¼”)
bolts, spacer blocks, washers and
knobs.
Support brace(Right)
Support brace(Left)
4 mm (1 ¾”) bolt
mm (2 ¼”) bolt
Spacer block
Washer
Washer
Knob
Knob
0mm(2”) bolt
32mm (1 ¼”) bolt
Footrest
Extender rail Foot
Leg
Barrel nut
Barrel nut
Loom side
Front rail
Support brace
Ashford HandicraftsLimited
41 West Street, P O Box 474, Ashburton, New Zealand
+64 3 308 9087
sales@ashford.co.nz
www.ashford.co.nz
ASSEMBLY INSTRUCTIONS
