Ashly Protea WR-1 Instruction Manual

For Immediate Release………..
ASHLY AUDIO RELEASES NETWORK FRIENDLY MATRIX PROCESSOR
Webster, NY -- Ashly Audio Inc. Ashly has released the new NE-Series (NE = Network
Enabled) ne24.24M Matrix Processor. Targeted for the installation market, this processor is
programmed and controlled using standard 10/100 Ethernet or RS-232 protocol and Ashly’s
easy to navigate Protea NE Software.
The ne24.24M Matrix Processor uses modular expansion cards providing up to twenty-four
channels of audio matrixing and processing. The base unit offers a four-input/four-output
configuration. Each input and output expansion card has an individual DSP processor allowing
you to expand the base unit’s total inputs or outputs four channels at a time. These cards are
easily installed in the field without the need to reprogram the device. Matrixing allows you to
route any input to any output and control individual levels once they have been assigned.
Fixed path architecture and extensive processing power per channel will reduce the amount of
time it takes to set up your system. All programming is accomplished using Ashly’s Protea NE
Software on a PC platform. No front panel controls and multi-level, multi-user software
security assures you a tamperproof audio system. An optional output module offers eight-
channel general purpose logic control to control room lighting, projection screens or other
controllable devices.
Input channel processing blocks include Mic Preamp with Phantom Power, Gain, Delay, fifteen
EQ Filters, Gate, Autoleveler and Ducker. Inputs may be configured as either mic or line level.
Output channel processing blocks consist of a Cross-Point Mixer, HPF/LPF, Delay, fifteen EQ
Filters, Gain and Limiter. The Cross-Point mixer in the output section allows you to route any
input to any output at any level and mute any input at any output without affecting the true
input configuration. The HPF/LPF block offers Bessel, Butterworth and Linkwitz-Riley filters
with 12, 18, 24 and 48dB per octave slopes.
Euroblock connectors for audio, preset recall, dc remote level control and data in/out
connections are on the rear panel and may be interfaced with Ashly’s WR-1, WR-2, WR-5 and
RD-8C Remote Control Accessories. An RS-232 data port is located on the front and rear
panel to allow for control either by a PC or third party device. New software supports
additional features including: Linking Support (Parameter Linking between channels and
blocks), Software/Canvas Support for custom control screens, Sub Presets to only recall what
changes and Push-To-Talk mic support
Whether you are designing or installing a system for corporate boardrooms, restaurants,
courtrooms, houses of worship, left/center/right theatres, auditoriums or conference centers,
the ne24.24M will more than satisfy your requirements for any zoned system requiring
input/output matrixing, signal processing and logic control.
For additional information contact: Jim Stachowski ([email protected])