Asko TL751 XXL Troubleshooting guide

TL751XXL DRYER TRAINING PROGRAM
TL751XXL DRYER TRAINING PROGRAM
4th Edition 05/15/2008

Program agenda
Program agenda
•
• General information General information
•
• Dryer operation Dryer operation
•
• Tear Tear- -down procedure / component down procedure / component
explanation
explanation
•
• Error codes Error codes
•
• Diagnostic mode Diagnostic mode
•
• Hands Hands- -on tear on tear- -down down

General Information
General Information
•
• Warranty Warranty
•
• Model/serial location Model/serial location
•
• Electrical considerations Electrical considerations
•
• Duct considerations Duct considerations
•
• Positioning of the unit Positioning of the unit
•
• Door swing Door swing

Product warranty
Product warranty
•
• Asko 2 Plus 1 Warranty Asko 2 Plus 1 Warranty
–
– 2 years from date of installation 2 years from date of installation
–
– 3 years provided the registration gets submitted 3 years provided the registration gets submitted
within 90 days of the installation
within 90 days of the installation
•
• Lifetime part warranty Lifetime part warranty
–
– Part only Part only – – stainless steel tank, drum or inner door stainless steel tank, drum or inner door
–
– Only if it fails to hold water due to a manufacturing Only if it fails to hold water due to a manufacturing
defect
defect

Product warranty
Product warranty
•
• Applies to all Asko appliances Applies to all Asko appliances manufactured manufactured
after January 1, 2008
after January 1, 2008
•
• Serial number identification Serial number identification
–
– 0801xxxxxxxx and higher 0801xxxxxxxx and higher
–
– Combo unit Combo unit – – 200801xxxxx and higher 200801xxxxx and higher

Model/serial tag location
Model/serial tag location

Electrical considerations
Electrical considerations
•
• 240 VAC 240 VAC
•
• 30 AMP 30 AMP
•
• 3 or 4 wire as designated by local code 3 or 4 wire as designated by local code

Duct considerations
Duct considerations
•
• Max length of 4 Max length of 4” ” diameter rigid metal duct diameter rigid metal duct – – 65 65’ ’
•
• Max length of 4 Max length of 4” ” diameter flex metal duct diameter flex metal duct – – 45 45’ ’
–
– Deduct 6 Deduct 6’ ’ for each elbow for each elbow
–
– No more than four 90 degree elbows if possible No more than four 90 degree elbows if possible
–
– Do not use plastic or thin foil duct material Do not use plastic or thin foil duct material
•
• Use as few joints as possible Use as few joints as possible
•
• Duct tape all joints Duct tape all joints

Positioning of unit
Positioning of unit
•
• ½” ½” clearance at the sides and top of unit clearance at the sides and top of unit
•
• Minimum of 6 Minimum of 6” ” clearance behind dryer clearance behind dryer
•
• Unit should be placed on a solid floor Unit should be placed on a solid floor
•
• Unit must be level Unit must be level
–
– Can effect tumbling action and humidity sensor Can effect tumbling action and humidity sensor
accuracy
accuracy
–
– Legs must be locked into place Legs must be locked into place

Door swing can be reversed
Door swing can be reversed
Left hinge door swing Right hinge door swing
Left hinge door swing Right hinge door swing