Astonica 40201141 User manual

Model No. 40201141
Two Tiered Country Fountain
Instruction Manual
Due to ongoing product development
the actual product or products may vary from
the illustrations or photos shown within this manual.
NOTE: This product is intended for residential, non-commercial use.
100611rev1
Read the instructions and precautions before use of this product
Please keep this instruction manual for future reference
®
Made in China
©2011 World Factory, Inc.
Distributed by:
World Factory, Inc.
Westlake, TX 76262
For warranty information, please refer to the back page of
this instruction manual.
Limited Warranty
World Factory, Inc. Products for Home Use
World Factory, Inc. (Seller) warrants to the original Buyer only, that each Astonica Product will be free
from defects in material and workmanship for a period of one (1) year from date of purchase.
SELLER’S SOLE OBLIGATION AND BUYER’S EXCLUSIVE REMEDY UNDER THIS LIMITED
WARRANTY SHALL BE THE REPAIR OR REPLACEMENT OF PARTS, WITHOUT CHARGE, WHICH
ARE DEFECTIVE IN MATERIAL OR WORKMANSHIP. ANY PARTS AS DETERMINED BY THE
SELLER WHICH HAVE BEEN MISUSED; ABUSED OR DAMAGED EITHER DIRECTLY OR INDIRECTLY
FROM REPAIRS OR ALTERATIONS ATTEMPTED BY UNAUTHORIZED PERSONS; IMPROPER
MAINTENANCE, NEGLECT OR ACCIDENT ARE NOT COVERED BY THIS LIMITED WARRANTY. This
warranty does not apply to damage, heat-induced coloration changes, scratching or alteration due to
normal use or weathering. To make a claim under this Limited Warranty, you must return the complete
product with proof of purchase, transportation prepaid, to any World Factory, Inc. authorized service
center. Call 1-888-424-3354 for the location of the nearest authorized service center.
Additional Limitations
THIS LIMITED WARRANTY DOES NOT APPLY TO ACCESSORY OR CONSUMABLE ITEMS RELATED
TO THIS PRODUCT. ALL IMPLIED WARRANTIES SHALL BE LIMITED IN DURATION TO ONE (1)
YEAR FROM DATE OF PURCHASE. IN NO EVENT SHALL SELLER BE LIABLE FOR ANY INCIDENTAL
OR CONSEQUENTIAL DAMAGES, INCLUDING BUT NOT LIMITED TO LIABILITY FOR LOSS OF
PROFITS, ARISING FROM THE SALE OR USE OF THIS PRODUCT.
If any provision of this Limited Warranty is for any reason held to be invalid or unenforceable, such
provision shall not affect any other provision herein, this Limited Warranty shall be construed as if
such invalid and/or unenforceable provision had never been contained herein.
This warranty gives you special legal rights, and you may also have other rights which vary from state
to state.
This Warranty contains the entire agreement between Seller and Buyer and supersedes any and all
prior agreements, arrangements, or understandings between the parties relating to product warranty.

ELECTRICAL SAFETY INSTRUCTIONS
WARNING! ELECTRICAL SHOCK. Read and understand all instructions. Failure to follow all
instructions listed below, may result in electrical shock, fire and/or serious personal injury.
SAVE THESE INSTRUCTIONS.
Grounding Instructions
This fountain must be plugged into a 3-wire, 3-prong outlet that is properly working and has
been installed and grounded in accordance with all local, state or federal codes and ordinances.
DANGER: IMPROPER INSTALLATION OF THE GROUNDING PLUG CAN RESULT IN A RISK OF
ELECTRICAL SHOCK. Check with a qualified electrician or serviceman if the grounding instructions
are not completely understood, or if doubt as to weather the product is properly grounded. Do not
modify the plug provided; if it will not fit the outlet, have a proper outlet installed by a qualified
electrician. Do not use any type of adapter with this product.
Attach Hand Pump Assembly
1. (SEE FIGURE 1) Face water faucet on hand
pump (C) towards tub opening and attach hand
pump to top of tub (A). Secure using
screws (E).
NOTE: Do not plug in pump before filling
tub with water. Running the pump without
water may damage pump.
Mount Small Wash Tub
1. (SEE FIGURE 2) Position small tub (A) over
large tub (B). Align mounting studs with
previously drilled holes at top of tub (B).
2. Install mounting studs through holes.
Secure tub (A) to tub (B) using bolts (F).
Install Hand Pump Assembly
1. (SEE FIGURE 3) Place Hand Pump with Pipe
(C) through top washtub (A) and then down
through bottom washtub (B).
2. Align Hand Pump with Pipe (C) over extension
tube at top of pump (D). Push down on Hand
Pump with Pipe (A) until fully seated.
3. Plug power cord into properly grounded
120V AC outlet.
4. (SEE FIGURE 4) Ready for use it.
Adjust Speed of Water Flow
1. Unplug pump (D) from AC power outlet.
2. Move adjustment switch on pump (D)
toward "+" positive to increase water
flow, or "-" to decrease water flow.
Maintenance
1. Check water level periodically, add
water if necessary.
2. If water is not flowing, check pump (D),
hand pump with Pipe (C) inside for clogs.
NOTE: Pump may build up calcium after a
long period of time and stop running when
tap water is used. Any calcium remover can
be used to clean pump.
PARTS & HARDWARE LIST
PART # DESCRIPTION QUANTITY
Carefully remove the contents from the package. If any parts are missing do not
attempt to use the product until they have been obtained and correctly installed.
CAUTION: Do not over tighten fasteners.
ASSEMBLY INSTRUCTIONS
B
C
DEF
A
Figure 2
Figure1
A
A
B
B
C
E
E
12
A Small Washtub 1
B Large Washtub 1
C Hand Pump with Pipe 1
D Pump 1
E Screw 3.5x20mm 3
F Bolt 6x25mm 2
Figure 3
Figure 4
D
C
A
FF