Astonica 40208212 User manual

Read the instructions and precautions before use of this product
Please keep this instruction manual for future reference
®
Model No: 40208212
Classical Fountain
Instruction Manual
310809rev1
For warranty information, please refer to the back page of
this instruction manual.
Made in China
©2012 World Factory, Inc.
Distributed by:
World Factory, Inc.
Westlake, TX 76262
Due to ongoing product development
the actual product or products may vary from
the illustrations or photos shown within this manual.
NOTE: This product is intended for residential, non-commercial use.
For Manuals, Replacement Parts or Customer Service visit:
www.ezreplacement.com
Limited Warranty
World Factory, Inc. Products for Home Use
World Factory, Inc. (Seller) warrants to the original Buyer only, that each Astonica Product will be free
from defects in material and workmanship for a period of one (1) year from date of purchase.
SELLER’S SOLE OBLIGATION AND BUYER’S EXCLUSIVE REMEDY UNDER THIS LIMITED
WARRANTY SHALL BE THE REPAIR OR REPLACEMENT OF PARTS, WITHOUT CHARGE, WHICH
ARE DEFECTIVE IN MATERIAL OR WORKMANSHIP. ANY PARTS AS DETERMINED BY THE SELLER
WHICH HAVE BEEN MISUSED; ABUSED OR DAMAGED EITHER DIRECTLY OR INDIRECTLY FROM
REPAIRS OR ALTERATIONS ATTEMPTED BY UNAUTHORIZED PERSONS; IMPROPER
MAINTENANCE, NEGLECT OR ACCIDENT ARE NOT COVERED BY THIS LIMITED WARRANTY. This
warranty does not apply to damage, heat-induced coloration changes, scratching or alteration due to
normal use or weathering. To make a claim under this Limited Warranty, you must return the complete
product with proof of purchase, transportation prepaid, to any World Factory, Inc. authorized service
center. Call 1-888-422-7800 or visit: ezreplacement.com for the location of the nearest authorized
service center.
Additional Limitations
THIS LIMITED WARRANTY DOES NOT APPLY TO ACCESSORY OR CONSUMABLE ITEMS RELATED
TO THIS PRODUCT. ALL IMPLIED WARRANTIES SHALL BE LIMITED IN DURATION TO ONE (1)
YEAR FROM DATE OF PURCHASE. IN NO EVENT SHALL SELLER BE LIABLE FOR ANY INCIDENTAL
OR CONSEQUENTIAL DAMAGES, INCLUDING BUT NOT LIMITED TO LIABILITY FOR LOSS OF
PROFITS, ARISING FROM THE SALE OR USE OF THIS PRODUCT.
If any provision of this Limited Warranty is for any reason held to be invalid or unenforceable, such
provision shall not affect any other provision herein, this Limited Warranty shall be construed as if
such invalid and/or unenforceable provision had never been contained herein.
This warranty gives you special legal rights, and you may also have other rights which vary from state
to state.
This Warranty contains the entire agreement between Seller and Buyer and supersedes any and all
prior agreements, arrangements, or understandings between the parties relating to product warranty.

ASSEMBLY INSTRUCTIONS
Carefully remove the contents from the package. If any parts are missing do not
attempt to use the product until they have been obtained and correctly installed.
PARTS & HARDWARE LIST
PART # DESCRIPTION QUANTITY
EH
G
K
D
2
1
A Large Basin 1
B Medium Basin 1
C Small Basin 1
D Post 1
E Pedestal 1
F Base 1
G Fountain Cap 1
H First Tier 1
I Second Tier 1
J Rubber Stopper 1
K Pump Assembly 1
L Screws 3
L
J
F
CAUTION: Do not over tighten fasteners.
2. (SEE FIGURE 2) Pass Pump Assembly
Power Cord (K) through the hole in the
Large Basin (A). Pull through until the
Rubber Stopper (J) fixed to the Pump
Assembly Power Cord can be pushed into
the hole to form a water-tight seal.
3. Assemble Pedestal and Post (D) to Base, (F)
passing Pump Assembly Power Cord
through each item as required.
1. (SEE FIGURE 1) Secure Pump Assembly (K) to
Large Basin (A) using the three screws (L).
4. (SEE FIGURE 3) Push the cascade tiers and
Medium and Small Basins onto the metal
pump spout. Screw the Fountain Cap (G)
onto pump Spout.
5. Place bath on a level surface and fill with
clean fresh water.
6. Connect the Pump Assembly Power Cord to
the nearest indoor AC Power Outlet.
7. Care: The bath will require a minimum of
1-gallon of water to function correctly.
Clean the pump with a soft bristled brush
and clean water. Flush through using a
garden hose. The flow rate of the pump can
be adjusted using the small lever at its
base. During hot weather the water can
evaporate quickly causing the pump to run
"dry" resulting in possible damage/failure
to the unit. Keep the large fountain basin
full and do not leave it running unattended.
If you notice the pump's performance
deteriorating, check for blockages and or
clean the pump.
The fountain should be placed on level
ground. Clean the pump and bath regularly.
Do not allow water to become overgrown
with algae. Do not place aquatic plants in
the fountain. Do not place pump in any
liquid other than clean water. Do not use in
water above 86 degrees Fahrenheit. Do not
lift, pull or carry the pump by the power
cord. Do not plug the transformer into an
outside socket. Do not run the pump "dry".
Figure 3
Figure 2 KB
K
A
L
L
ABC
I
Parts Detail List
J
Pump Assembly
Power cord
H
G
A
B
C
I
Figure 1
Metal Spout
Metal Spout