Asus vudu Instruction Manual

Wireless Kit
Designed exclusively for use with the VUDU product.
©2008 VUDU, Inc. All Rights Reserved.
Start Here

FCC Warning Statement
This device complies with Part 15 of the FCC Rules. Operation is sub-
ject to the following 2 conditions:
1) this device may not cause harmful interference, and
2) this device must accept any interference, including interference that
may cause undesired operation.
This device has been tested and found to comply with the limits for a
Class B digital device, pursuant to part 15 of the FCC rules. These limits
are designed to provide reasonable protection against harmful interference
in a residential installation.
This equipment generates, uses, and can radiate radio frequency energy
and, if not installed and used in accordance with the installation instruc-
tions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment
off and on, the user is encouraged to try to correct the interference by one
of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the outlet into an outlet on a circuit different from that to which
the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
CAUTION: Any changes or modifications not expressly approved by the
party responsible for compliance could void the user’s authority to operate
the equipment.
Prohibition of Co-Location
This device and its antenna(s) must not be co-located or used in conjunc-
tion with any other antenna or transmitter.
Safety Information
To maintain compliance with FCC’s RF exposure guidelines, this equip-
ment should be installed and operated with a minimum of 20 cm between
the radiator and your body. Use only the supplied antenna.

(1) USB to DC power cable
What’s Included
(2) Ethernet cables
(1) AC to DC power cable
Wireless adapter
Wireless adapter

Locate one of the two included Ethernet cables. Connect
one end to the wireless adapter marked
Connect the other end to your home network router or
modem.
.
1.

Locate the included AC to DC power cable. Insert
one end into the DC-IN socket of
Plug the other end into a wall outlet.
2. .

LED LIGHTS
The LED indicators for Power and Ethernet on
will light up.
3.
LED INDICATORS

Locate the other of the two included Ethernet cables.
Connect one end to the wireless adapter marked .
Connect the other end to your VUDU box.
1.

Locate the included USB to DC power cable.
Insert one end into the DC-IN socket of
Connect the other end to one of the USB ports on
the VUDU box—on the back or left side.
2. .

LED INDICATORS
The LED indicators for Power and Ethernet on
will light up.
3.
The LED indicators for Power and Ethernet on
will light up and, after a few seconds, the LED indicator for
Wireless will start blinking. The wireless adapters have been set
up successfully.
Going forward, all three LED indicators on both wireless adapt-
ers should be illuminated. When the LED indicators for Wireless
and Ethernet start to blink, data is being transmitted.
Should you have any questions or problems, please refer to the
Wireless Kit Instructions at www.vudu.com/vudu_documenta-
tion.html or call Customer Care at 1-888-554-8838 (VUDU).