ATD Tools ATD-8630 User manual

ATD-8630
45 PIECE TIRE REPAIR TOOL KIT
Product Information
Set Includes:
z1pc – T-handle Insert Tool
z1pc – T-handle Spiral Probe Tool
z2pc – Hex Key
z40pc – 4” Tire Repair String (Tire Plug)
z1pc – Lubricant
Safety Precautions
Caution: To help prevent personal injury
zDo not use the tool outside of the designed intent. Never modify the tool for any other purpose, or
for its use.
zNormal use of this product is likely to expose the user to dust and/or microscopic particles
containing chemicals known to the State of California to cause cancer, birth defects or other
reproductive harm.Always wear appropriate safety equipment and clothing when using this product.
Study, understand and follow all instructions provided with this product.
zAlways wearANSI approved goggles when using this product.
zAlways select the correct accessories of the correct size and design for the job that you are
attempting to perform.
zAlways work in a clean, safe, well-lit, organized and adequately equipped area.
zDo not begin repairs without assurance that vehicle is in secure position, and will not move during
repair.
Important
Read these instructions carefully before installing, operating, servicing or repairing this tool.
Keep these instructions in a safe accessible place.

INSTRUCTIONS:
1. Insert the T-handle Spiral Probe Tool into the punctured tread at a slight angle then straighten the
tool and push the tapered shaft in and out of the hole several times to expand and enlarge the
broken steel cord.
2. Prepare T-handle Insert Tool for insertion by first dipping the tip into the lubricant.
2-1 Next insert the tire repair string (tire plug) through the hole in the installer tool.
2-2 Make sure that the tire repair string (tire plug) is fairly well centered in the shaft prior to installation.
3. Insert the tire repair string (tire plug) into the hole and push straight down on the insert tool handle
till the ends of the tire repair string (tire plug) are sticking out of the tire 1/2” to 1”.
4. Pull the T-handle Insert Tool straight out of the hole till the tip is just even with the tire tread then cut
the exposed tire plug ends just slightly above the tread and remove the installation tool.
5. After airing up the tire to its correct tire pressure spray the tire repaired area with a soapy water and
check that the puncture is sealed and not leaking.