ATD Tools ATD-5480 User manual

• Makesuretubingiscutoffsquareandburrsremoved.
• Chamferoutsideoftubingwitheitherafileorgrindingwheel.
• Inserttubingthroughtwosidesofclampingbaseusingincludedadapterasguidefor
properlength.
• Alternatetighteningthetwocapscrewsoftheclampingbasetogripthetubing.Too
looseagripwillallowthetubingtopushthrough.
• Insertstemofadapterintoendoftubing.(SeeDiagram1)Placehexyokeoverflaring
adapterandhandtightenontoclampingbase.(Donotusewrenchtotighten)(See
Diagram2)
• ThreadflaringscrewintoHexyoke.Screwuntiltightandfirmwhichwillproducethe
firstflare.Thiswillformabellshapeintubing.(SeeDiagram3)
• Unthreadscrewuntilloose.
• UnthreadHexyokecompletelyandremoveadapter.Checkforproperbellshape.
• ReplaceHexyokeandtightentobase.
• Threadscrewintohexyokeagainuntilcompletelytight.Thisshouldcompletethe
doubleflare.
INSTRUCTIONSFORINLINEFLARING
ATD-5480

Diagram 1
Diagram 2
Diagram 3
REV.B

PARTS LIST
ATD5480 - Automotive In Line Flaring Tool
164-200
Center Screw In Line Flaring Tool
164-500
Hex Yoke, In Line Flare Tool
164-100
3/16 - 4.75mm In Line Bar Clamp
163-3A
3/16” Flare Adapter
163-23
4.75mm Adapter
164-300
Cap Screw
Learn more about hand tools on our website.