ATEN 2X-EA08 User manual

All information, documentation and specifications contained in this media are subject to change without prior notice by the manufacturer.
Please visit our website to find the most up-to-date version.
Lok-u-Plug Cable Holder 2X-EA07
Lok-u-Plug Installation Tool 2X-EA08
Installation Guide
05/2023 V2.0
Package Contents
2X-EA07
2X-EA08
Qty
Description
Qty
Description
10
Lok-u-Plug Cable Holder
4
Lok-u-Plug Installation Tool
1
installation instructions (printed on packaging)
1
installation instructions (printed on packaging)
The ATEN-patented Lok-u-Plug secures your power cables in place on an ATEN PDU device to prevent undesired
disconnection in events such as device repositioning and movement. For Lok-u-Plug securing, the Lok-u-Plug Cable
Holder (2X-EA07), must be used in conjunction with the Lok-u-Plug Installation Tool (2X-EA08).
Installation
To secure a power cable in place, using a Lok-u-Plug Cable Holder and Installation Tool, do the following:
1. Bend a Lok-u-Plug Cable Holder, and put the power cord to be secured through the middle of the Cable Holder as
shown.
2. Plug the power cord into the PDU’s power outlet,
and thread one end of the Lok-u-Plug Cable Holder
into the lower left hole next to the power outlet.
3. Using a Lok-u-Plug Installation Tool, lock the part of
the Cable Holder inserted into the hole by pushing it
towards the small part of the hole.

All information, documentation and specifications contained in this media are subject to change without prior notice by the manufacturer.
Please visit our website to find the most up-to-date version.
4. Push the Cable Holder as close to the PDU as possible. Then thread its other end to the upper right hole next to
the power outlet, and lock it in place using the Installation Tool by repeating step 3.
5. Slide the left and right rings of the Cable Holder towards the middle so that the power cord is completely fastened
to finish.
Suggested Installation Sequence
1. Plug in all of the Lok-u-Plug Cable Holders, for the power cords that you want to secure, but only secure them to
the lower left holes.
2. After securing to the lower left holes, then secure them to the upper right holes.
2
1
5