TX3O14 DUAL PRIORITY VOICE OPERATED MUTING MODULE
FOR THE SA SERIES MIXER AMPLIFIERS & TX SERIES MIXERS
I NSTALLATION I NSTRUCTIONS
Thank you for choosing an Audio Telex TX3014 dual priority voice operated mtte module. The TX30l4 allows for muting of
channels 2-6 when signal is present at channel I and also mute drannels 3-6 when signal is present at channel 2. Installation into
either the Audio Telex 5A60, SA120, TX6000 or TX8000 is made simple by utilising a standard 'end' type connector plug supplied
on the module and a receptacle, wtrich is already installed into the mixer or "rnptifie". Please follow^these easy instructions for
installation. .
I The installation of the TX3014 involves access to the inside of the mixer or amplifier. Installation should only be
attempted by a qualified technician. Always turn olf the AC power and remove the AC power cord before attempting
to access the inside of these products. Please contact your nearest Audio Telex ofrice for details of your nearest
qualified technician.
For installation into the SA SERIES mixer amplifiers: Locate the 8 pin 'end' connector found on location X3 on the mixer
PCB in between the input gain pots for Ch. 2 and Ch. 3. This 'end' connector is divided into two separate parts consisting of 5 pins
and 3 pins. Remove both these filler plugs and discard. Connect the module to this receptacle, ensuring that the black trace found on
the wires of the module is facing the front of the amplifier.
For installation into the TX SERIES mixers: As per installation insfuctions above for the SA SERIES mixer amplifiers.
Notes
The TX30l4 is not suitable for installation into any oth€r models of Audio Telex mixers or amplifiers other than those listed above.
For voice operated muting suitable for other models please refer to either the TX30l0 or TX3028 modules.
UN toN