AUDIOLINE TEL5 clip User manual

Telefon
Telephone
Bedienungsanleitung
Operating Instructions
TEL5 clip

− Contents −
17
1 General Information 19. . . . . . . . . . . . . . . .
1.1 Intended use 19. . . . . . . . . . . . . . . . . . . . . . . . . . . .
1.2 Installation location 19. . . . . . . . . . . . . . . . . . . . . . .
1.3 Private branch exchanges 19. . . . . . . . . . . . . . . . .
1.4 Information on disposal 20. . . . . . . . . . . . . . . . . . .
1.5 Temperature and ambient conditions 20. . . . . . . .
1.6 Cleaning and upkeep 20. . . . . . . . . . . . . . . . . . . . .
2 User Controls 21. . . . . . . . . . . . . . . . . . . . . .
2.1 Inside the receiver 21. . . . . . . . . . . . . . . . . . . . . . .
2.2 Upper side of receiver 21. . . . . . . . . . . . . . . . . . . .
2.3 Underside of base unit 22. . . . . . . . . . . . . . . . . . . .
2.4 Inside of base unit 22. . . . . . . . . . . . . . . . . . . . . . .
3 Setting up 23. . . . . . . . . . . . . . . . . . . . . . . . .
3.1 Safety Information 23. . . . . . . . . . . . . . . . . . . . . . .
3.2 Check contents of pack 23. . . . . . . . . . . . . . . . . . .
3.3 Connecting the receiver 23. . . . . . . . . . . . . . . . . . .
3.4 Fitting the batteries 23. . . . . . . . . . . . . . . . . . . . . . .
3.5 Connecting the telephone 23. . . . . . . . . . . . . . . . .
3.6 Wall mounting 24. . . . . . . . . . . . . . . . . . . . . . . . . . .
3.7 Adjust date and time 24. . . . . . . . . . . . . . . . . . . . .
4 Operation 25. . . . . . . . . . . . . . . . . . . . . . . . . .
4.1 Making a call 25. . . . . . . . . . . . . . . . . . . . . . . . . . . .
4.2 Receiving calls 25. . . . . . . . . . . . . . . . . . . . . . . . . .
4.3 Call Duration Display 25. . . . . . . . . . . . . . . . . . . . .
4.4 Adjusting the receiver volume 25. . . . . . . . . . . . . .
4.5 Redial facility 25. . . . . . . . . . . . . . . . . . . . . . . . . . . .
4.6 Adjusting the receiver volume 25. . . . . . . . . . . . . .
4.7 Storing speed dial numbers 26. . . . . . . . . . . . . . . .
4.8 Calling up speed dial numbers 26. . . . . . . . . . . . .
5 Caller display (CLIP) 27. . . . . . . . . . . . . . . .
5.1 Viewing the caller list 27. . . . . . . . . . . . . . . . . . . . .
5.2 Dialling a telephone number directly from the caller
list 28. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
5.3 Deleting telephone numbers from the caller list 28
5.4 Deleting the entire caller list 28. . . . . . . . . . . . . . .

− Contents −
18
6 Private Branch Exchanges /
Supplementary Services 29. . . . . . . . . . . .
6.1 R−button on Private Exchanges 29. . . . . . . . . . . .
6.2 R−button and supplementary services offered by
your telephone network provider 29. . . . . . . . . . .
6.3 Dialling pause 29. . . . . . . . . . . . . . . . . . . . . . . . . . .
7 Important information 30. . . . . . . . . . . . . .
7.1 Fault finding 30. . . . . . . . . . . . . . . . . . . . . . . . . . . . .
7.2 Guarantee 30. . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
8 Important Notes on the Guarantee 31. . .

− General Information −
19
1 General Information
Please read this operating instruction manual thoroughly.
Under no circumstances open the device or complete any
repair work yourself. In the case of claims under the terms of
guarantee, contact your sales outlet. We reserve the right to
make technical and optical modifications to the product
during the course of product improvement.
1.1 Intended use
This telephone has been developed for use when connected
to an analogue telephone network connection (PSTN).
However, due to the different services offered by the various
telecommunication network providers, there is no guarantee
that the equipment will function trouble−free on every
telecommunication terminal connection. Only connect the
telephone line from the telephone to a telephone line socket
designed for it. Never change the plug on the connection
cable.
1.2 Installation location
Place the telephone on a level, non−slip surface. Normally,
the footpads on the telephone do not leave any marks on
the surface where it is located. However, due the diverse
types of paints and surfaces which come into question, it
cannot be fully ruled out that the footpads will leave marks
on the surface on which it is located.
1.3 Private branch exchanges
The telephone can also be connected to a private branch
exchange. Ask the dealer where your private branch
exchange was purchased whether the telephone will
function properly on the private branch exchange. There is
no guarantee that the telephone will work on every private
branch exchange.

− General Information −
20
1.4 Information on disposal
The implementation of European law in national laws and
directives obliges you to dispose of consumable goods
appropriately. This serves to protect both persons and the
environment.
The adjacent symbol indicates that
electrical and electronic apparatus no l
onger required must be disposed of s
eparate from domestic waste.
Equipment which is old or has outlived
its service life must be disposed of at a
suitable collection point provided by the
public waste authorities.
Batteries and power packs must be disposed of at the
point of sale or at the appropriate collection
points provided by the public waste authorities.
Packaging materials must be disposed of according to
local regulations.
1.5 Temperature and ambient conditions
The telephone is designed for use in protected rooms with a
temperature range from 10 °C to 30 °C. The telephone
should not be used in rooms exposed to moisture, such as
bathrooms or laundries. Do not locate the device in the
vicinity of sources of heat such as radiators, and never
expose it to direct sunlight.
Prevent excessive exposure to smoke, dust, vibration,
chemicals, moisture, heat and direct sunlight.
1.6 Cleaning and upkeep
Clean the housing surfaces with a soft, dry, fluff−free cloth.
Never use cleaning agents or solvents. Apart from
occasionally cleaning the housing, no other upkeep is
necessary. The rubber footpads on the telephone are not
resistant to all cleaning agents. The manufacturer is not
liable for any claims for damage to furniture or such.

− User controls −
21
2 User Controls
2.1 Inside the receiver
1. Disconnect button/
receiver rest
2. Speed dial button
3. Store button
4. Connection to base unit
5. R Signal button
6. Redial / Pause
7. Receiver volume
adjustment
2.2 Upper side of receiver
8. Indicator light for new
calls
9. Selector key, down
10. Selector key, up
11. Delete button
12. Dialling from the
caller list
1
2
3
4
5
6
7
8
9
10
11
12

− User controls −
22
2.3 Underside of base unit
1. Fixing for wall mounting
2. Connection for
telephone cable
3. Fixing wall mounting
4. Connection for spiral
receiver cable
5. Ringer volume
adjustment
2.4 Inside of base unit
6. Battery compartment
3
2
1
4
5
6

− Setting up −
23
3 Setting up
3.1 Safety Information
Caution: Before setting up, it is essential that you
read the General Information at the beginning of
this manual.
3.2 Check contents of pack
The following items are supplied:
one telephone base one telephone receiver
one telephone connecting
cable
one spiral cable
one instruction manual three AA batteries
3.3 Connecting the receiver
After unpacking your telephone, you must first connect the
telephone receiver to the telephone base. First take one end
of the spiral cable and plug it into the socket at the bottom of
the receiver. Turn the telephone over and plug the other end
into the lower socket (see Chapter 2, Section entitled
Underside of base unit, Item 4.). Bring the cable out via the
cable duct.
3.4 Fitting the batteries
Before connecting your new telephone to the telephone
network, the batteries should be fitted. Please always use a
good type of AA batteries. No messages will be shown in the
display if the batteries are not fitted. Before installing or
changing the battery, make sure that the telephone is not
connected to the telephone network.
1. The battery compartment is to be found on the
inside of your telephone base.
2. Open the battery compartment with a small
screwdriver or a pointed object.
3. Insert the batteries, ensuring that the polarity is
correct.
4. Close the battery compartment.
The battery should be changed when the \symbol
appears in the display. All three batteries must then be
changed. If the batteries become discharged, the display will
go dark.
3.5 Connecting the telephone
Connect the telephone cable supplied to the telephone
socket and the telephone jack on the underside of the

− Setting up −
24
telephone base (see Chapter 2, Section entitled Underside
of base unit, Item 2.). Then feed the cable out of the
telephone housing through the cable guide either towards
the top or the bottom. Secure the cable firmly in the cable
duct. The telephone works using the MF system (Tone
Dialling).
3.6 Wall mounting
Your telephone is also suitable for wall mounting. Use two
screws for fixing to the wall. Drill two holes 85 mm apart,
vertically one above the other, and leave the screws
protruding 5 mm from the wall. Now place the telephone
base over the screws and push down slightly.
When the telephone is mounted on a wall, you can hang the
receiver on the telephone without cutting off the call. A small
hook is located at the top of the receiver rest for this
purpose.
3.7 Adjust date and time
1. Press the button yfor 4 seconds.
2. Press the yor zbutton to set the contrast in
the LC display.
3. Confirm with the Cbutton.
4. Press the yor zbutton to set the Recall
time (100 ms or 300 ms).
5. Confirm with the Cbutton.
6. Enter the current hour by repeatedly pressing the
yor zbuttons.
7. Confirm with the Cbutton. The display jumps to
the minutes display.
8. Enter the current minutes by repeatedly pressing
the yor zbuttons.
9. Confirm with the Cbutton. The cursor jumps to
the day display.
10. Enter the current day by repeatedly pressing the
yor zbuttons.
11. Confirm with the Cbutton. The cursor jumps to
the month display.
12. Enter the current month by repeatedly pressing
the yor zbuttons.
13. Confirm with the Cbutton. This completes the
entries and the current data will now be shown in
the display.
Note: If the batteries are fully discharged, the time and
date must be re−entered.

− Operation −
25
4 Operation
4.1 Making a call
Your telephone can be used like any conventional
telephone.
1. Lift the receiver and wait until you hear the dialling
tone.
2. Now dial the required telephone number. The
display can show a telephone number with a
maximum of 14 digits. If the number dialled is
longer than this, only the last 14 digits will be
displayed.
3. To end the call, replace the receiver on the rest.
You can end the current call by using the
disconnect button and you will immediately obtain
a new dialling tone.
4.2 Receiving calls
When a call comes through, you will hear the ringing tone.
The call can now be accepted using the receiver.
4.3 Call Duration Display
The call duration is shown in the display in minutes and
seconds during a call. The indication starts after the number
has been dialled. The call duration still remains showing in
the display for a few seconds after the call has been ended.
4.4 Adjusting the receiver volume
If the receiver volume is too quiet or too loud for you, you
can change this to suit your requirements.
You can adjust the volume from soft to loud using
the VOL. slide switch on the receiver.
4.5 Redial facility
If a connection that you have dialled is engaged or you were
unable to get through to anybody, simply replace the
receiver. The last number dialled remains stored in the
telephone automatically. To use the redial facility, proceed as
follows:
Lift the receiver and press the redial button F. The stored
redial number will now be dialled.
4.6 Adjusting the receiver volume
By means of the slide switch on the right side of the
telephone base you can choose the settings (loud) or
(soft) to match the volume of the ringing tone to your
requirements. If at any time you do not want to be disturbed,
use the (off) setting.