Audiovox XMEXT50 User manual

50' EXTENSION KITFor use with all XM Satellite Radio Systems*
• Indoor/Outdoor
• Extends the installation options
of XM Satellite Radio in any
invironment
For additional information:
Call 1.800.942.TERK (8375)
or visit www.terk.com
For additional information about XM Satellite Radio service
visit www.xmradio.com
Made in China
One year limited warranty
The XM name and related logos are trademarks of
XM Satellite Radio inc.
TERK and TERK Technologies are trademarks of
TERK Technologies Corp. Commack, NY
©2004 TERK Technologies Corp.
136P003
50 feet
RG-58
2300 to 2400 MHz
10dB +/- 1 dB @ 2300 MHz
-10dB
SMB
Cable Length
Cable Type
Frequency
Amplifier Gain
Return Loss
Connectors
Installation instructions printed on the inside of this card.
Specifications
To install your XM-EXT50 please follow the
instructions and illustrations listed below:
Step 1 Yes NoStep 2 Step 3
Step 1 Step 2 Step 3
Remove rubber boot as shown. Insert antenna's connector
through the rubber boot as
illustrated and into amplifier's
connector. Replace rubber boot.
Insert the cable's connector
into the connector marked
ANT or Antenna on the XM
receiver or Plug & Play system.
Please refer to the XM-EXT50 user guide included with your receiver to complete your XM system set up.
DO NOT attempt to cut, splice or otherwise shorten the cable!
Any remaining length should be carefully coiled.
DO NOT kink the cable. Avoid bending cable with a bend
radius of less then 1 inch.
DO NOT expose the cable to severe environmental
conditions. Care should also be taken to avoid direct
and high moisture areas.
DO NOT link more than two extension kits.
Warning
Please mount amplifer
upright as shown above.
LINE OUT DC IN 6V ANT