AUSTRALIAN MONITOR ZM3 User manual

A More Thorough Examination...
The Australian Monitor Zone Mix 3 is an extremely versatile & innovative mixer & signal router.
Featuring a broadcast quality audio spec, the Zone Mix 3 allows remote selection of 4 stereo sources
to 3 stereo zones, one stereo source can have selectable priority per zone & each stereo zone
boasts 5 stage equalization. The Zone Mix 3 also has the ability to route two independent mic or
line signals to any single zone or combination of zones. Add to this remote volume control & source
selection in each zone via the ZM3R remote & the ZM3M 3 zone paging microphone
(both running via inexpensive CAT5 cabling) & you have an extremely
high quality Zone selecting mixer at a fraction of the
cost of other products in this market.
At a Glance
Australian Monitor Zone Mix
3 Stereo Zone Mixer
Just some of the ZM3’s features include...
> 4 stereo program inputs > Bi colour status LED per zone
> 2 mic/line inputs > Remote enabled LED per zone
> ZM3M paging mic able to page > Separate gain trims for each program,
any combination of zones mic/line & paging input
> Sum input with overall priority > Security covers for EQ & gain sections
> 3 Stereo zone outputs > Link bus for expansion to a second ZM3
> 5 stage EQ per zone > 1RU chasis
> Remote source select & volume
control via ZM3R remote
ZM3

Dimensions (mm) 44.0h x 482.0w x 286.5d
Shipping dimensions 110 x 505 x 400
Weight Net 2.5kg (5.5lb)
Shipping 3.0kg (6.6lb)
Power Input 20VAC; 30VA max
Sensitivity (for 0dB out) Mic/Line Input (RCA) 86mV (-19dB)
Mic/Line Input (XLR) 1.55mV (-54dB)
Prog Input (RCA) 190mV (-12dB)
Max Level Out 10V RMS (+22dB)
Frequency Response 20Hz - 20kHz (0dB/-3dB)
THD Less than 0.1%
Noise -80dB
Crosstalk Better than 65dB
Phantom Power 15VDC
- All measurements done with levels set to max;
- All measurements referenced to 0dBu (0.775mV)
The 1RU zone mixer shall be of a high specification suitable for foreground and background music
applications. The unit shall have a frequency response of 20Hz-20kHz (0dB/-3dB) and signal to
noise of -80dB or greater.
The zone mixer shall feature three stereo zone outputs (with 5 stage EQ), two mic/line inputs
and four stereo line inputs. The inputs may be routed to any of the outputs.
Program source selection may be made via the front panel or a remote wall panel connected by
CAT-5 cable.The unit shall have an optional microphone paging station which allows the paging
of the 3 individual zones or all zones at once.
The unit shall be an Australian Monitor ZoneMix3.
Architectural and
Engineering Specifications
Engineered and Distributed by AUDIO TELEX COMMUNICATIONS PTY LTD (ABN 78 001 345 482), 149 Beaconsfield Street, Silverwater, Sydney, NSW, 2128 Australia
NSW Tel: [phone] Fax: [phone] VIC Tel: [phone] Fax: [phone] QLD Tel: [phone] Fax: [phone] WA Tel: [phone] Fax: [phone]
SA Tel: [phone] Fax: [phone] NZ Tel: [phone] Fax: [phone] International Enquiries - [email protected] www.australianmonitor.com.au