Auvon 3-IN-1 TENS+EMS+Massage Device User manual

Relaxation, Anywhere, Anytime
Start Here
Quick Start Guide
AUVON ® 3-IN-1
TENS+EMS+Massage Device

A. How to assemble the unit.
1. Upload batteries.
Step 2
Open the lid.
Step 1
Push and press the
corner of clip as the
picture shows with
your left thumb and
pull down with your
right hand.
Step 3
Upload the batteries.
Make sure the ribbon is
behind the batteries.

2. Connect lead wires to machine.
3. Connect lead wire pins to pads.
4. Stick pads to therapy area.
Step 3
Upload the batteries.
Make sure the ribbon is
behind the batteries.

Please know before use
B. How to operate the unit.
Steps to use pre-set modes.
Press any “▼” buttons to unlock the machine when the
screen shows a “ ”.(The machine will be locked if you
don’t press any button within 30 seconds.)
*Pre-set modes: P1-P10(TENS)&P12-P21(EMS)&
P23-P32(Massage)
(1) Press P to select
pre-set modes
(2) Press ▲/▼to increas/
decrease intensity.

(3) Press MENU to make
waveform flashing.
(4) Press ▲/▼to select waveform.
Flash

Steps to use manual modes.
*Manual modes: P11(TENS)&P22(EMS).
(1) Press P to select
manual modes.
(2) Press ▲/▼to increase/
decrease intensity.
(3) Press MENU to make
time flashing.
(4) Press ▲/▼to select times
(including continuous time)
Flash Continuous
time

(6) If P22(EMS), just repeat above steps of P11 to get started，
the user can also adjust rise time, action time, fall time and rest
time.
● Please read User Manual 1, page 24 to know what the
rise/action/fall/rest time is.
● This guide is not intended to replace or substitute the user
manual.
● Please read User Manual 1 and User Manual 2 complete-
ly before using the device.
-------------------------------------------
-------------------------------------------
(5) Repeat press MENU again to set up waveform,
frequency, pulse width.
Note:
Waiting for 5
seconds or
press MENU
to save all
settings.
------Waveform
----Pulse Width
----Time
Frequency ---