AVT Ninja 250 Fender Eliminator User manual

AVT Ninja 250 Fender
Eliminator Install Guide
1)Remove the lower seat cover on each side of
the bike. First remove the Philips screw and
then carefully full on to cover at each corner to
get it to pop out.
2)Remove the seat by unscrewing the two 5mm
hex bolts(one on each side). Lift the seat out of
place.
3) Remove the rear seat with your motorcycle
key.
4) Removeboth the rear fairings. You will need
to remove: sixtotal 4mm hex bolt from both the
rear fairings.
5) Reach your hand into the fairing as pictured
and start to pop it out of place. Even steady
pressure works best. Lift the fairings out of the
way.

6)Replace the standard relay with the upgrade
LED relay: Unplug the OEM relay and pull up to
remove it.
7) Remove the OEM Fender: 1) Unplug the four
electric connectors. 2)Unscrew the four 5mm
hex bolts.
8) Remove Top Light cover by pulling up on it(its
secured with Velcro) and lower the OEM fender
out of the way. *please note how the wires are
routed in order to reinstall the new ones
properly.
9) Remove the OEM tail light by unbolting the
two 10mm bolts. You will reuse these bolts, the
nut bracket that they screw into, as well as the
rubber inserts from the OEM light to assemble
your new LED tail light in the next step.
10)Assemble the upgraded LED tail light as
pictured by reusing the OEM tail light bolts, the
nut bracket that they screw into, as well as the
rubber inserts(to take these out of the OEM
light you will first need to first take out the
#1
#2
Two of the connectors are
under the seat.

metal insert out of the rubber portion. Do not
reuse the metal portion of the inserts)that you
removed in the previous step. Note that you do
add the supplied plastic bracket to the bottom
of the assembly.
11) Install your licenses plate on the licenses
plate holder. Align the tail light assembly to the
licenses plate holder and put one of the
supplied bolts through the bottom. Start to
align the fender eliminator into the proper
location on the bike. Feed the electrical cable
through into the original location.Secure fender
eliminator in place with the supplied bolts.
12) Connect the electric connectors:
1)rectangular white tail light harness(with 3
wires) 2) white rectangular plug to black
rectangular plug.3)orange plug to black plug 4)
light blue plug to gray plug.
13) Reinstall the tail light cover and reposition
both the rear fairings into place on the bike.
You will need to squeeze together the fender
eliminator and the rail light cover to get the
rear fairings to slip on with the rear garment.
#1
#2
#3
#4

14)Reinstall the rest of the components in
reverse order:
1) rear fairings
2)rear and front seats
3) lower seat covers
Congratulations on successfully installing your
New Ninja 250 AVT Fender Eliminator!
Thank you for your order, AVT.
www.avt-innovations.com