AVT Ninja 650 NI User manual

AVT Ninja 650 NI Fender
Eliminator Install Guide
1) Remove the rear seatwith your motorcycle
key. Remove the front seat by pulling back and
up.
2) Remove the rear right and left fairings that
are secures with 1) a s #4 hex bolt and 2) (2)
8mm bolts. The firings slide out towards the
rear of the bike and out.
3) 1) Remove the (2) 8mm bolts securing the tail
light. 2) Remove the (4) #5 hex bolts holding the
fender.
4) Unplug the 3 electrical plugs coming out of
the OEM fender on the right side of the bike.
5)Remove the OEM fender: At this point the
entire rear fender section will sag a bit and you
will need to remove 1 Philips screw on the
inside of the fender to release it. Also release
the wires from their OEM location noting how
they were routed.
#2
#1
#2
#1

6) Install you new AVT fender eliminator: Feed
the wires form your new fender eliminator into
the OEM location and attach the fender
eliminator bracket with the (2) OEM #5 hex
bolts and nuts provided through the rear set of
hols. Feed the bolts from the botom up.
7) Connect the electric connectors: 1)white
rectangular plug to black rectangular plug.
2)orange plug to black plug 3) light blue plug to
gray plug.
6) Reinstall the rest of the components in
reverse order:
1: (2) 8mm tail light bolts
2: the two rear fairings
3: the front and rear seats
4: license plate
Congratulations on successfully installing your
New Ninja 650 AVT NI Fender Eliminator!
Thank you for your order, AVT.
www.avt-innovations.com
#2
#3
#1