Digital door spy DDS 2
73-002.2 (11-14)
Operation – Use of camera
Visitors / view camera image
- In the main menu, press the On/Off key to activate the
camera.
- The ring tone sounds when the door bell is pressed. The
screen turns on automatically and shows the camera image.
A photo of the camera image is also saved. The image turns
off again when the set time has lapsed.
- In the main menu, press the key to save a photo of the
camera image.
Viewing and removing photos
- In the main menu, press the key to view the photos.
- Press the or key to scroll through the photos.
- Keep the key pressed to remove the photo.
- Confirm removal of the photo with the key .
Automatic saving of photos
- Photos can be saved to the appliance
(standard) or to a TF memory card.
Memory card installation
- A TF memory card is not included. This must be purchased by
the user.
- Install the TF memory card before placing the
batteries.
- To install the TF memory card, slide the metal memory card
holder towards the "Open" symbol.
- Pop the metal memory card holder up and place the TF
memory card in the holder.
- Pop the memory card holder back and slide the holder
towards the "Closed" symbol.
- Max. 8GB TF memory cards can be used.
Higher than HSC Class 6 is recommended.
Specifications Internal memory: About 50 photos
Door thickness: 38-110 mm (depending on surroundings)
Camera hole size: Ø14 -22 mm Sensor: 0.3 Mega Pixels CMOS
LCD screen: 3.2 inch TFT Memory card: Micro SD (TF), max. 8GB
Resolution: QVGA (320x240) Power: 4x AAA batteries
Dimensions (wxhxd): 125 x 85 x 18,5 mm Weight: 260 grams
Assembly manual
For problem-free operation of this product you must follow
the instructions below carefully.
Assembly
1Place the batteries 4in the door spy.
2Replace the existing door spy or drill a hole (Ø 14 mm) at eye
level. Remove the foil from the double-sided camera tape 7
and insert the camera through the door from the outside.
Ensure that the bell head 6points straight down (figure A).
Do not fold or pull on the camera connecting cable
3 Disassemble the mounting plate 5at the bottom of the
screen 1by unscrewing 2the bolt(figure B).
4Remove the foil of the double-sided tape on the back of the
mounting plate(figure B).
5Insert the camera connecting cable 8through the mounting
plate and stick the mounting plate with the arrow pointing
upwards, to the inside of the door. Screw the mounting sleeve
9onto the camera thread using the mounting key 10
(figure C).
The arrow on the mounting plate must point upwards
6Carefully connect the camera plug to the back of the screen.
7Hook the screen over the top of the mounting plate and
secure the unit using the bolt (figure D).
8The AXA Digital door spy is ready for use.
B
C D
Door
A
