iv
Safety Precautions
Before getting started, read the following important safety precautions.
1. The OFP215 Series does not come equipped with an
operating system. An operating system must be loaded first
before installing any software into the computer.
2. Be sure to ground yourself to prevent static charge when
installing the internal components. Use a grounding wrist
strap and place all electronic components in any
static-shielded devices. Most electronic components are
sensitive to static electrical charge.
3. Disconnect the power cord from the OFP215 Series before
any installation. Be sure both the system and external
devices are turned OFF. A sudden surge of power could ruin
sensitive components that the OFP215 Series must be
properly grounded.
4. Make sure it is the correct voltage of the power source before
connecting the equipment to the power outlet.
5. The brightness of the flat panel display will be getting weaker
as a result of frequent usage. However, the operating period
varies depending on the application environment.
6. Turn OFF the system power before cleaning. Clean the
system using a cloth only. Do not spray any liquid cleaner
directly onto the screen. The OFP215 Series may come with
or w/o a touchscreen. Although the touchscreen is chemical
resistant, it is recommended that you spray the liquid cleaner
on a cloth first before wiping the screen. In case your system
comes without the touchscreen, you must follow the same
procedure and not spray any cleaner on the flat panel
directly.
7. Avoid using sharp objects to operate the touchscreen.
Scratches on the touchscreen may cause malfunction or
internal failure to the touchscreen.
8. The flat panel display is not susceptible to shock or vibration.
When assembling the OFP215 Series, make sure it is
securely installed.
9. Do not leave this equipment in an uncontrolled environment
where the storage temperature is below -20℃or above 60℃.
It may damage the equipment.
10. External equipment intended for connection to signal
