Axor Single Lever Lav Mixer 10100801 Assembly instructions

09/2005
HANSGROHE PRODUCT SERVICE
SINGEL LEVER LAV MIXER
Ref. No.: 10100801
Installation
Starck
Installation (1)
Attention: The mixer must connected to angle valves with integrated filter.
The mixer can not used together with a continuous flow water heater.
1. Flush through the supply pipes.
2. Place the mixer including the sealing washer in position on the basin.
3. Slip the slide washer, washer and collar nut over the threaded base and tighten the
collar nut by hand.
4. Tighten screws.
5. Connect the connecting hose to the angle valves; cold right - hot left.
6. Install the battery (please see Exchange battery)
Large differences in pressure between the hot and cold water supply should be balanced.
Operation
The water temperature is adjusted by the adjusting lever.
swivel forward = hot water,
swivel backward = cold water.
Adjustment (2)
This mixer have following feature:
background fade-out with integrated range adjustment, that means the mixer is automati-
cally adjusted on to the local conditions (washbasin, brightness, reflection) by the sensory
mechanism.
Exchange battery (3)
The mixer operates with a 6 V Lithium-Battery
(DL 223A). The working life of the battery is 2 years by extremely operation. Over night
the current consumption is reduced by a economy mode.
Push a small hexagon socket screw key into the hole at the backside of the mixer and pull
the cover upwards. Take care to the O-ring.
Attention: After installing the battery, the mixer may not activated for 1 min because of
adjusting itself.
Cleaning washbasin (4)
Cover the infrared sensor by hand, after 4 s remove slowly the hand , the automatic
water stop is activated for 1 min.
adjusting lever
infrared sensor with
light emitting diode
(LED)
cover
1
2
3
7 7/8"+3/8"
coldhot

09/2005
HANSGROHE PRODUCT SERVICE
Spare parts
LED-Display
LED off: normal operation
LED light: replacing battery
LED flashes every 2 s: water stop is activated
Technical data
Operation pressure: max. 117 psi
Recommended pressure: 14.7 - 72.5 psi
Test pressure: 232 psi
Hot water temperature: max. 176 ° F
Recommended hot water temperature: 149 ° F
Rate of flow: 1,7 gpm by 45 psi
Maximum flowing-out temperature at 122 ° F
temperature difference and 45 psi flow pressure:108 °F
Follow-on time: 1,5 s
Rise-delay time: 300 ms
Automatic switching-off: after 1 min
battery: 6 V / 1300 mAh Lithium
1 battery 97399000
2 connecting hose
3 battery box with cover 96317800
4 areator 94005800
5 fixation set 13961000
1
3
5
2
4

09/2005
HANSGROHE PRODUCT SERVICELimited Lifetime Consumer Warranty
This product has been manufactured and tested to the highest quality standards by Hansgrohe, Inc. („Hansgrohe“).
This warranty is limited to Hansgrohe products which are purchased by a consumer in the United States after March
1, 1996, and installed in either the United States or Canada.
WHO IS COVERED BY THE WARRANTY
This warranty extends to the original consumer purchaser only.
WHAT IS COVERED BY THE WARRANTY
This warranty covers only your Hansgrohe manufactured product. Hansgrohe warrants this product against defects
in material or workmanship as follows: Hansgrohe will repair at no charge for parts only or, at its option, replace
any product or part of the product which proves defective because of improper workmanship and/or material, under
normal installation, use, service and maintenance. If Hansgrohe is unable to provide a replacement and repair is not
practical or cannot be timely made, Hansgrohe may elect to refund the purchase price in exchange for the return of
the product.
LENGTH OF WARRANTY
Replacement or repaired parts of products will be covered for the term of this warranty as stated in the following two
sentences. If you are a consumer who purchased the product for use primarily for personal, family, or household
purposes, this warranty extends for as long as you own the product and the home in which the product is installed.
If you purchased the product for use primarily for any other purpose, including, without limitation, a commercial
purpose, this warranty extends only (i) for 1 year, with respect to Interaktiv and Retroaktiv products, and (ii) for 5
years, with respect to AXOR, ShowerPower and Pharo products.
THIS WARRANTY DOES NOT COVER, AND HANSGROHE WILL NOT PAY FOR:
A. Conditions, malfunctions or damage not resulting from defects in material or workmanship.
B. Conditions, malfunctions or damage resulting from (1) improper installation, improper maintenance, misuse,
abuse, negligence, accident or alteration, or (2) the use of abrasive or caustic cleaning agents or „no rinse“
cleaning products, or the use of the product in any manner contrary to the product instructions.
C. Labor or other expenses for the disconnection or return of the product for warranty service, or for installation or
reinstallation of the product.
D. Accessories or related products not manufactured by Hansgrohe.
TO OBTAIN WARRANTY SERVICE
Contact your Hansgrohe retailer, or write to Technical Service at:
Hansgrohe Inc.
1492 Bluegrass Lakes Parkway
Alpharetta GA 30004
Or, call Hansgrohe toll-free at [phone].
In requesting warranty service, you will need to provide
1. The sales receipt or other evidence of the date and place of purchase.
2. A description of the problem.
3. Delivery of the product or the defective part, postage prepaid and carefully packed and insured, to Hansgrohe
Inc. 1492 Bluegrass Lakes Parkway, Alpharetta, Georgia 30004, Attention: Technical Service, if required by
Hansgrohe.
When warranty service is completed, any repaired or replacement product or part will be returned to you postage
prepaid.

09/2005
HANSGROHE PRODUCT SERVICE
EXCLUSIONS AND LIMITATIONS
REPAIR OR REPLACEMENT (OR, IN LIMITED CIRCUMSTANCES, REFUND OF THE PURCHASE PRICE) AS
PROVIDED UNDER THIS WARRANTY IS THE EXCLUSIVE REMEDY OF THE PURCHASER. HANSGROHE
NEITHER ASSUMES NOR AUTHORIZES ANY PERSON TO CREATE FOR IT ANY OBLIGATION OR
LIABILITY IN CONNECTION WITH THIS PRODUCT.
HANSGROHE SHALL NOT BE LIABLE TO PURCHASER OR ANY PERSON FOR ANY INCIDENTAL,
SPECIAL, OR CONSEQUENTIAL DAMAGES, ARISING OUT OF BREACH OF THIS WARRANTY OR ANY
IMPLIED WARRANTY (INCLUDING MERCHANTABILITY).
Some States do not allow the exclusion or limitation of incidental or consequential damages, so the above limitation
or exclusion may not apply to you.
This warranty gives you specific legal rights, and you may have other rights which vary from State to State.
You may be required by law to give us a reasonable opportunity to correct or cure any failure to comply before you
can bring any action in court against us under the Magnuson-Moss Warranty Act.
PRODUCT INSTRUCTIONS AND QUESTIONS
Upon purchase or prior to installation, please carefully inspect your Hansgrohe product for any damage or visible
defect. Prior to installing, always carefully study the enclosed instructions on the proper installation and the care and
maintenance of the product. If you have questions at any time about the use, installation, or performance of your
Hansgrohe product, or this warranty, please call or write to us at the toll-free number and address printed above.
9.08940.01 Rev. 01
Cleaning Recommendation for Hansgrohe Products
Modern faucetry and shower products utilize a combination of materials to comply with the needs of the market with
regard to design and functionality.
To avoid damage, it is necessary to use some caution when cleaning. Damage caused by improper treatment is not
covered under the Hansgrohe warranty.
Cleaning Materials for Faucets and Showers
• To remove lime scale, use only products made specifically for that purpose. Always follow the manufacturer’s
instructions when using.
• Do not use cleaners that contain hydrochloric, formic, acetic, or phosphoric acids, as these will cause considerable
damage to finishes and to plastic components.
• Never mix cleaning materials.
• Never use cleaners containing abrasives. Do not use abrasive cleaning cloths, pads, or sponges.
Cleaning Procedures
• Clean your faucets and shower products as and when required. Regular cleaning will prevent scale buildup and
water spotting.
• Follow the label instructions. Do not allow any cleaner to remain on the product for longer than necessary.
• When using spray cleaners, spray first onto a sponge or cloth – do not spray directly onto the product.
• After cleaning, rinse thoroughly with clear water to remove any cleaner residue.
Important
• Soap and shampoo residue can also cause damage to the product. Rinse well with clean water after use.
• If the surface is already damaged, harsh cleaning materials will cause further damage.