Axor Starck 10920001 Installation guide

Starck X
10920001
Installation Instructions / Warranty

2
Technical Data
Flow rates @ 45 psi
Showerhead 2.5 gpm
Handshower 2.5 gpm
Bodysprays 4.3 gpm
Maximum water pressure 145 psi
Recommended water pressure: 40 - 75 psi
Recommended hot water temp.: 120°F - 140°F*
A check valve is installed in the handshower outlet.
The high temperature limit stop may be reset to comply with local plumbing codes. See page
5.
This unit is listed by IAPMO and is approved for use in Massachusetts.
Please save this document as it contains user, maintenance and warranty
information.
*Please know and follow all applicable local codes when setting the temperature on the water heater. In
Massachusetts, the water heater may be set no higher than 112°F.
•
•
•
•
Starck X Waterwall
10920001

3
Preparation
The Waterwall requires 1/2” NPT male nipples, extend-
ing 5/8” outside the surface of the finished wall for the
hot and cold water supplies.
For proper operation of the thermostatic mixer, the hot
supply should be on the left and the cold supply should
be on the right.
Finish and seal the wall prior to installation of the
Waterwall.
Flush the supply lines thoroughly before installation.
Installation
Drill the holes for the top and bottom mounting brack-
ets, using a 6 mm bit. Install the anchors. Seal around
the anchors with waterproof sealant.
Screw the mounting brackets to the wall with the screws
provided.
Wrap the threads on the nipples with Teflon tape. Install
the elbows so that the outlets face upwards.












Seal the wall around the nipples and
anchors with waterproof sealant.
Failure to seal the wall can lead to
possible water damage.

4
Push the shower arm into place on the Waterwall.
Tighten the set screw, using the Allen wrench
(included).
Hang the shower wall on the top mounting bracket.
With a helper holding the panel, attach the hoses to
the elbows.
Install the bottom retaining screw and tighten with a
screwdriver.
Carefully install the showerhead on the shower arm.
Insert a hose washer in one end of the handshower hose.
Connect this end to the Waterwall.
Insert the screen washer in the other end of the hose. Con-
nect this end to the handshower.
Place the handshower in the holder on the side of the
Waterwall.

5
Remove the thermostatic mixer handle. Carefully remove
the retaining clip and the stop ring from the stem.
Turn the water on to the handshower. Place a thermom-
eter in the water stream. Turn the thermostatic mixer stem
until the water coming out is the maximum allowable
output temperature (usually 110° - 112°F).
Reinstall the stop ring so that it buts against the stop.
Reinstall the clip.
Set the High Temperature Limit Stop (optional)
Justify the Thermostatic Mixer Handle
Turn on the water to the handshower.
Place a thermometer in the water stream. Turn the thermo-
static mixer handle until the water coming out measures
100°F. Turn the water off.
Save time and frustration: if turning the thermostatic
mixer handle gives both hot and cold water, but the
water does not mix, the hoses have been connected to the
incorrect supplies. Please disconnect the hoses, reattach
them to the correct supplies and test the unit before
calling the Hansgrohe Technical Service center.
Remove the thermostatic mixer handle and the safety set.
Reinstall the safety set so that the indicator is at the 12:00
position.
Reinstall the handle so that the safety stop override button
is at the 12:00 position.
Tighten the handle screw and replace the screw cover.

6
User Instructions
Using the Thermostatic Mixer: turn the handle clockwise to obtain cooler water and counter-
clockwise to obtain warmer water. The handle will stop when the water temperature is 100° - this
is the safety stop. To obtain water than 100°F, push the safety stop override button and continue
turning the handle counter-clockwise.
To turn on the water to the desired function(s), turn the corresponding volume control
handle(s).
Using the handshower: The Starck handshower has two spray modes, full and soft spray.
Turn the end of the handshower to select the spray mode.
Cleaning: The showerhead and handshower use the Quick Clean™ self-cleaning function. If
scale deposits are noticed in the spray channels, turn the water on lightly and rub across the chan-
nels with a finger or a sponge to clear them.
Replacement parts
1 escutcheon 97338000
2 shower arm 97339000
3 head shower 28494001
4 cover 96483000
5 handle for thermostat 96519001
6 safety set for temperature control 95041000
7 thermostat cartridge 94282000
8 handle 97340000
9 handle 97441000
10 handle 97341000
11 sleeve 97342000
12 shut off unit 94009000
13 handshower 28532001
14 escutcheon 97343000
15 hose 28282000
16 check valve DW 15 94074000
17 bodyspray 21867000
18 mounting kit 97344000
19 hose connection elbow 98531001
20 connection hose 1500 mm 25965000
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
18
19
20

7
Limited Lifetime Consumer Warranty
This product has been manufactured and tested to the highest quality standards by Hansgrohe, Inc. (“Hansgrohe”). This
warranty is limited to Hansgrohe products which are purchased by a consumer in the United States after March 1, 1996, and
installed in either the United States or Canada.
WHO IS COVERED BY THE WARRANTY
This warranty extends to the original consumer purchaser only. This warranty is non-transferable.
WHAT IS COVERED BY THE WARRANTY
This warranty covers only your Hansgrohe manufactured product. Hansgrohe warrants this product against defects in material
or workmanship as follows: Hansgrohe will repair at no charge for parts only or, at its option, replace any product or part of
the product that proves defective because of improper workmanship and/or material, under normal installation, use, service
and maintenance. If Hansgrohe is unable to provide a replacement and repair is not practical or cannot be timely made,
Hansgrohe may elect to refund the purchase price in exchange for the return of the product.
LENGTH OF WARRANTY
Replacement or repaired parts of products will be covered for the term of this warranty as stated in the following two sentenc-
es. If you are a consumer who purchased the product for use primarily for personal, family, or household purposes, this war-
ranty extends for as long as you own the product and the home in which the product is originally installed. If you purchased
Cleaning Recommendation for Hansgrohe Products
Modern lavatory faucets, kitchen faucets, and showers consist of very different materials to comply with the needs of the
market with regard to design and functionality. To avoid damage and returns, it is necessary to consider certain criteria when
cleaning.
Cleaning Materials for Faucets and Showers
Acids are a necessary ingredient of cleaning materials for removing lime, however please pay attention to the following points
when cleaning faucets and showers:
Only use cleaning materials which are explicitly intended for this type of application.
Never use cleaning materials which contain hydrochloric, formic, phosphoric, or acetic acid, as they cause considerable
damage.
Never mix one cleaning material with another.
Never use cleaning materials or appliances with an abrasive effect, such as unsuitable cleaning powders, sponge pads,
or micro fiber cloths.
Cleaning Instructions for Faucets and Showers
Please follow the cleaning material manufacturer’s instructions. In addition, pay attention to the following points:
Clean the faucets and showers as and when required
Use the amount of cleaning product and the amount of time recommended by the manufacturer. Do not leave the cleaner
on the fixture longer than necessary.
Regular cleaning can prevent calcification.
When using spray cleaners, spray first onto a soft cloth or sponge. Never spray directly onto the faucet as droplets can
enter openings and gaps and cause damage.
After cleaning, rinse thoroughly with clean water to remove any cleaner residue.
Important
Residues of liquid soaps, shampoos, and shower foams can also cause damage, so rinse with clean water after using.
Please note: if the surface is already damaged, the effect of cleaning materials will cause further damage.
Components with damaged surfaces must be replaced or injury could result.
Damage caused by improper treatment is not covered under the warranty.
•
•
•
•
•
•
•
•
•

Hansgrohe, Inc. •1490 Bluegrass Lakes Parkway •Alpharetta, GA 30004
Tel. [phone] •Fax [phone]
www.hansgrohe-usa.com
US - Installation Instructions •Part No. 90573703 •Revised 03/2008
the product for use primarily for any other purpose, including, without limitation, a commercial purpose, this warranty extends
only (i) for 1 year, with respect to Hansgrohe and Commercial products, and (ii) for 5 years, with respect to AXOR products.
THIS WARRANTY DOES NOT COVER, AND HANSGROHE WILL NOT PAY FOR:
A. Conditions, malfunctions or damage not resulting from defects in material or workmanship.
B. Conditions, malfunctions or damage resulting from (1) normal wear and tear, improper installation, improper mainte-
nance, misuse, abuse, negligence, accident or alteration, or (2) the use of abrasive or caustic cleaning agents or “no-
rinse” cleaning products, or the use of the product in any manner contrary to the product instructions. (3) Conditions in the
home such as excessive water pressure or corrosion.
C. Labor or other expenses for the disconnection, deinstallation, or return of the product for warranty service, or for installa-
tion or reinstallation of the product (including but not limited to proper packaging and shipping costs), or for installation or
reinstallation of the product.
D. Accessories, connected materials and products, or related products not manufactured by Hansgrohe.
TO OBTAIN WARRANTY PARTS OR INFORMATION
Contact your Hansgrohe retailer, or contact Technical Service at:
Hansgrohe Inc.
1492 Bluegrass Lakes Parkway
Alpharetta GA 30004
Toll-free [phone].
In requesting warranty service, you will need to provide
1. The sales receipt or other evidence of the date and place of purchase.
2. A description of the problem.
3. Delivery of the product or the defective part, postage prepaid and carefully packed and insured, to Hansgrohe Inc. 1492
Bluegrass Lakes Parkway, Alpharetta, Georgia 30004, Attention: Technical Service, if required by Hansgrohe.
When warranty service is completed, any repaired or replacement product or part will be returned to you postage prepaid.
EXCLUSIONS AND LIMITATIONS
REPAIR OR REPLACEMENT (OR, IN LIMITED CIRCUMSTANCES, REFUND OF THE PURCHASE PRICE) AS PROVIDED UNDER
THIS WARRANTY IS THE EXCLUSIVE REMEDY OF THE PURCHASER. HANSGROHE NEITHER ASSUMES NOR AUTHORIZES
ANY PERSON TO CREATE FOR IT ANY OBLIGATION OR LIABILITY IN CONNECTION WITH THIS PRODUCT.
HANSGROHE SHALL NOT BE LIABLE TO PURCHASER OR ANY PERSON FOR ANY INCIDENTAL, SPECIAL, OR CONSE-
QUENTIAL DAMAGES, ARISING OUT OF BREACH OF THIS WARRANTY OR ANY IMPLIED WARRANTY (INCLUDING
MERCHANTABILITY).
Some States do not allow the exclusion or limitation of incidental or consequential damages, so the above limitation or exclu-
sion may not apply to you. This warranty gives you specific legal rights, and you may have other rights which vary from State
to State. You may be required by law to give us a reasonable opportunity to correct or cure any failure to comply before you
can bring any action in court against us under the Magnuson-Moss Warranty Act.
PRODUCT INSTRUCTIONS AND QUESTIONS
Upon purchase or prior to installation, please carefully inspect your Hansgrohe product for any damage or visible defect.
Prior to installing, always carefully study the enclosed instructions on the proper installation and the care and maintenance of
the product. If you have questions at any time about the use, installation, or performance of your Hansgrohe product, or this
warranty, please call or write to us or call us toll-free at 800 334 0455.