8
2. Correct leveling of the printer build plate (important)
Setting the build plate presents an important step, which decisively determines
the quality of the printed product. If the distance between the printer head and
the build plate is too big, it can result in the first layer not sticking to the base.
If the distance is too short, the printer head or the build plate can be damaged.
2.1. Leveling the build plate
By pressing the button in the menu put the printer head in the start position –
choose Return Home. In this position, find the optimum height of the Z-axis,
which needs to be 0.1mm away from the build plate. Check the height by
putting a piece of A4 100 g paper under the printer head.
Check the first point and set it with a screw on the upper side, then press the
Return Home button in the menu again, so that the head is put in the start
position. Check the height again with a piece of A4 100 g paper.
WARNING:
When taking the printer out of the packaging, the build plate needs to be reset.
By using the menu move towards the center of the build plate and repeat the
procedure. Carefully move the paper under the printer in all directions and make
sure it remains undamaged.
Modulation screw
