B9Creator B9Creator v1.2 User manual

1
The B9Creator™
Copyright 2013 B9Creations, LLC All Rights Reserved
Visual Assembly Guide, v1.1
Step 6 - Final Assembly (2 of 2)
Completed B9C reator

2
Window Assembly
Windows are secured t o fra me s with SA18 hardware.
Peel the protective paper off the acrylic windows before proceeding.
Windows are placed on the inside of the frames.

3
Do not over tighten the nylon nuts.
Note the orientation of the top window with clearance "notch" toward the handle screw holes.

4
Windows installation finished.

5
Hatch Handle Installation

6
Handle secured with screws.

7
Attaching Hinge to XA Assembly

8

9
Attaching Left Side Frame & Foot ("printer's left" side)
Note that four sets of the SA15 hardware were used in the last procedure. The remaining four sets will
be used now, two on the left side and two on the right.
The SA15 screws are slightly longer than the SA17 and are used where we need to attach 3 layers of
aluminum parts (vs only 2 layers for the shorter SA17 screws).

10
Held in place with one SA17 (do not fully tighten until all screws are started). Note alignment of the
power input jack and Arduino USB port.

11
Attached with three sets of SA17 and two sets of SA15. Securely tighten all screws before finishing.
Attach foot with two SA17 screws, tighten securely.

12
Attaching Right Side Frame & Foot
Similar to left side but without power & USB ports.

13
Both sides attached.

14
Attaching Hatch to Hinge
Attached Hatch, note hinge flap on inside lip of hatch.

15
Attaching Self Adhesive Magnetic Hatch Strips
There are four magnetic strips, place two together with adhesive sides "out". Trim length with scissors if
needed.
Remove protective paper from lower strips and affix to top lip of ZA as shown.
Remove protective paper from top strips. Carefully close hatch to correct position and press in place.

16
Hatch closed.
Top magnetic strips now adhered to hatch.

17
Attaching Self Adhesive Hatch Cushion Pads
Peel each off of protective paper.
Attach to inside front of hatch.

18
Hatch in closed position with cushions and magnetic strips.
The purpose of the hatch and windows is to block higher frequency light (blue and above) from curing
the resin. Red and lower frequency light will not cure the resin. It also acts as a dust cover.

19
Attaching Self Adhesive Wall Standoff Pads
Peel each of t he six pads off and affix th e m t o the back of unit as shown below.
The Pad's purpose is to cushion the unit if mounted to a wall.

20
Sweeper Assembly & Attachment
Note there are "back" and "front" brackets. In the above photo the "back" is the one on left and the
"front" is the one on the right.
Sweeper with flap installed and rubber wiper edge in place.Gravity holds the flap in place, it can be
removed for easy cleaning after a print.