Babymore Pecan User manual

Pecan i-Size Baby Car Seat
USER MANUAL
WARNING
7
NOTICE
Babymore
Unit C2, Zenith Industrial Estate, Paycocke Road Basildon, Essex, SS14 3DW.
Telephone: [phone]
Email: [email protected]
www.babymore.co.uk
R129/03
Approved under European ECE R129/03
Manufactured in accordance with ISO9001:2015 quality management system standards

1.Applicability.............................................................................3
2.Safety instrucons...................................................................4
3.Parts and interior equipment..................................................5
4.General use..............................................................................6
4.1. Adjusting the carrying handle. .............................................6
5.Installaon in car......................................................................7
6. Correct securing your baby.....................................................8
6.1.Setting the shoulder belt heig ............................................8
6.2.Adjust the shoulder straps.....................................................9
6.3.Securing the baby with the harness.....................................9
6.4.The use of buckle.................................................................10
7.Care and Maintenance..........................................................11
7.1.Remove the fabric cover.....................................................11
7.2. Cleaning of the fabric cover...............................................11
7.3.Care and Maintenance........................................................11
8.What to do aer an accident.................................................11
Contents
32
NOTES
The following brief instrucons are intended to provide only an
overview. In order to achieve maximum security and comfort for your
child it is absolutely imperave that you read the whole instrucon
manual carefully. Order of tasks: set up infant car seat-strap the child
in- install infant car seat in the vehicle.
1. Applicability
DO NOT put the baby car seat on seats on which a front
airbag is acvated.
● Only suitable for vehicle seats with a three point automac belt,
approved under ECE regulaon no R.16 or equivalent standard.
AIR BAG
Stature : 40- 87cm
Mass limit: ≤13kg

54
3.Parts and interior equipment.
! ! ! ! ! ! ! ! !
! ! ! ! ! ! ! ! ! ! ! ! ! !
!
! ! ! ! ! ! ! ! ! ! ! ! ! ! !
! ! ! ! ! ! ! ! !
g ! ! ! ! ! ! ! ! ! !
! ! ! ! ! !
g ! ! ! ! ! ! ! ! ! ! !
! ! ! ! ! ! ! ! g
g ! ! ! ! ! ! !
! ! ! ! ! ! ! ! !
g ! ! ! ! ! ! ! ! ! !
! ! ! ! ! !
! ! ! ! ! ! ! ! ! ! ! ! !
! ! ! ! ! ! ! ! ! ! !
! ! ! ! ! !
g ! ! ! ! ! ! ! ! ! ! ! ! ! ! !
! ! !
! ! ! ! ! ! ! !
! ! ! !
! ! ! ! ! ! ! ! ! ! !
! ! ! ! ! !
! ! ! ! ! ! ! ! ! !
! !
! ! ! ! ! ! ! ! ! ! ! ! ! !
! ! ! !
! ! ! ! !
! ! ! !
g ! ! ! ! ! ! !
!
•
!
HGG
!! !
lI
!
joi
! !
•
!
HGG
!!
lI
!
joi
! ! ! !
lI)
g ! !
3iGj
! ! ! !
Im
!
!
lIjm
!
joi
! ! !
3iGj
! !
)
! !
joi
!
3iGj
! ! !
jmm
! !
! ! ! !
Imj
! ! ! !
lI
! !
! ! ! !
!.def
!.def
1
7
12
10
13
2
9
8
3
5
6
4
11
15
14
1.Buckle
2.Harness release Button
3.Handle
4.Canopy
5.Handle button
6.Belt guide slot
7.Shoulder pad
8.Harness belt strap
9.Buckle pad
10.Fabric cover
11.Headrest adjusting handle
12.Shoulder pad
13.Insert cushion
14.buckle hook button
15.Seat belt adjustment button
stature:≤60cm

76
Fig.1 Fig.2 Fig.3 Fig.4
4.General use
4.1. the carrying handle
● You can lock the carrying handle into 4 .
● To adjust the carrying handle, please simultaneously press the red
on both sides.
● Then rotate the carrying handle it locks in the
place in the desired .
Fig. 1
rear of the vehicle on the vehicle seat (the child’s feet point towards to
the backrest of the vehicle seat).
Fig .2:Straight up for carrying.
Fig.3
Fig.4
inside.
● Always strap your child in with the integrated belt system and make
Fig.2
Fig.3
Fig.1
5. in car
●Please read the manuals in order to protect all passengers.
●Do not put this infant car seat on a seat with front airbag.
●The infant car seat can be suitable for vehicle seats with a three point
belt.
●The infant baby car seat must be installed rearward facing( the child’s
feet point towards to the backrest of the vehicle seat).
Step 1. Ensure the carrying handle in the
forward .
Put the infant car seat in vehicle ’s seat (
Fig.1), put the infant car seat against
the backrest of the vehicle seat.
Step 2.Slide the lap belt of the vehicle’s
3-point seat belt through both lap belt
guides.Let the tongue plate snap in the
belt lock with a clearly audible“click”.Pull
the shoulder belt in narrow to
the lap belt.Check to make sure
the tongue plate is locked by pulling on
the belt(Fig.2).
Step3.Place the diagonal belt in the
diagonal belt guide at the back of the seat
. rotate the handle of the seat to the
appropriate place in the car.(Hearing “
click”) Be sure the handle has been locked
and it should be firmly against the
backrest of vechile’s seat Fig. .
Step 4.Tighten the vehicle’s own 3-point
seat belt by pulling hard on the ns
showed in fig.4.
Fig.4
! child in with the integrated belt system.

98
Fig.6 Fig.7
the backrest of car seat.
● You can release the child if you act the above steps in reversal
ways.
Also check that the cover is not impeding the movement or fit of
the belt webbing in any way.
to the child car seat is incorrect as the Fig 6. Fig.7 You can contact
the child car seat manufacturer if in doubt about this point.
-Too high
-Too low
6.Correct securing your baby
6.1. the shoulder belt height
Check whether the shoulder belts be at the right height for your
child. The should belts should be at shoulder height or just above.
6.2.Adjust the shoulder straps
● The shoulder straps are slackened by
pressing the lever (under the seat cover) on the
.taes eht fo tnorf
● Press down eho
as you grip the two shoulder straps with
your other hand. Pull the shoulder straps
towards you to loosen it.
6.3.Securing the baby with the harness
1.Firstly, adjuse shoulder straps height (see point 6.1),proceed as
follows.
2.Loosen the harness(see point 6.2),open the buckle, and place them
down sideways. put your child in the child car seat. Place both
shoulder straps over your child’s shoulders.
3.Lock the buckle .
4.Ensure that the straps are close to the shoulder oe child by
pulling the straps .
Height adjustment of the headrest and shoulder strap:
Pull up the headrest adjusting handle,the headrest and
the shoulder strap move up synchronously.
Press down the headrest adjusting handle and move the
headrest down synchronously with the shoulder
strap.
Caution! Please loosen the seat safety belt before
adjusting the height of the headrest.loosen the
shoulder harness (see point 6.2)

1110
Fig.1 Fig.2 Fig.3
● The harness should be adjusted as tightly as
possible without causing discomfort to your
child.
● It is dangerous not to tighten the straps. Check
the adjuster and be sure that the straps are
pulled tightly, not twisted after installati
everytime
6.4.The use of buckle
1.Put the two metal sections of the buckle connectors together (fig.1)
2.Slot the two buckle connectors into the slot in the top of the buckle
until hearing “click”(fig.2)
3.Check the harness is correctly locked by pulling the shoulder straps
upwards (fig.3).
4.To release the harness, press the red button on the buckle
downwards.
30
P
THIS COVER SHOULD BE HAND WASH
Step 2:Undo the press button on the handle, then remove the
canopy from backwards.
Step 3:Loosen the elastic, remove the fabric cover from upwards
● Follw the steps described above but in reverse order in order to
re-fasten the cover.
7.2 Cleaning of the fabric cover
Use only neutral detergent and warm water to wash the fabric
cover.Do not wash it by machine,spin-dry or tumble-dry are not
recommended.
7.3.Care and Maintenance
1.Please regularly check the function and spare parts of the baby car
seat are in good condition to provide the maxinum protectio
2.Before using, please check the locking fastness of the buckle by
pulling in effort the straps and see whether the buckle is loose or not.
3.Do not use the baby car seat in cold,wet or hot circumstance for a
long time
8.What to do aer an accident
Please change the seat without fail after an accident
WARNING! Never use harsh cleaning or bleaching agents!
WARNING! The belt system cannot be dismantled!
Never remove individual parts of the belt system!
You can clean the belts with a clean cloth and some lukewarm
soapy water. Try to avoid getting the belts too wet.
7.Care and Maintenance
7.1.Remove the fabric cover
Step 1:First pull out the harness from the seat.