Baja Designs S2 Pro User manual

Baja Designs S2 Pro LED Light - Wide Cornering Beam
Installation Guide for Jeep Wrangler '07-'18 4-Door JKU
Installation Time: <1 Hour
Tools Required:
Allen Wrench
Wiring Harness
Installation Instructions:
1. Remove the light and hardware from packaging and locate the mount. Thread the bolt and washer through
before attaching the mount to the light (Figure A).
Figure A
2. Slide a split-washer onto both side bolts before using to attach mount to light (Figure B).

Figure B
3. Thread a bolt through the mount hole into the light housing (Figure C).
Figure C
4. Thread the other bolt through, as well (Figure D).

Figure D
5. Tighten the bolts using an Allen wrench (not supplied) (Figure E).
Figure E
6. Attach the mount section of the light to an LED mount (not included) and tighten the supplied nut (Figure F).

Figure F
7. Attach the supplied quick connect to a wiring harness (not supplied) and run the harness to the light mounting
location (Figure G).
Figure G
8. Connect the light to the wiring harness (Figure H).

Figure H

Before
After
Installation Instructions Written by ExtremeTerrain Customer J. Sandlin 08/26/2018