bajaj electricals limited Page 5of 5
Place ingredients in mixer/grinder jar and put lid in position. Place jar on basic unit and turn the lower socket
clockwise to lock the jar.
Plug in. Support dome gently by hand and switch on to blend/grind using lower speed (1). And then moving on to,
higher speeds.
Switch off after blending/grinding. Unplug. Unlock and lift the jar from the basic unit. Pour out the contents (Fig. –
8/9).
MOTOR OVERLOAD PROTECTION
The Juicer-Mixer-Grinder is fitted with a heavy duty universal
motor using a winding wire that can withstand extremes of
temperatures. Therefore, the chances of motor failure are
extremely rare.
It is however possible that the mixer motor may get overloaded
when you attempt to grind quantities in excess of those
recommended in this book.
The motor of the Juicer-Mixer-Grinder is protected by a resetting
type Over Load Protector (OLP). In case of overloading, the OLP
disconnects the power supply to the motor. In such an
eventuality, switch off the supply. Remove the excess load or add
water to the ingredients, if the recipe so permits. Wait for a few
minutes. Reset the OLP located below the base plate and restart
the mixer. (Fig. -10).
CARE & CLEANING
Cleaning of the Juicer
•To clean the filter mesh, fill cleaning bottle with soap water, fit brush onto bottle and insert in mesh cleaning
shutter. Switch on by pushing button (1) Ensure that a glass or bottle is kept under the spout to collect the
dirty water.
•Move brush up & down across the juicer mesh while squeezing bottle to squirt water from brush (Fig. -11).
Cleaning of the Mixer & Grinder Jars
•After each use it is desirable to wash and thoroughly clean
the jars
•For cleaning, fill up the jar with water up to half its
capacity. A small quantity of detergent or liquid soap will
help clean better, especially after use with sticky or oily
foods. Fix the jar on the mixer-grinder base and run for
about 15 to 20 seconds. The blade rotating at high speed
in water, will clean the jar thoroughly and remove all food
material stuck on the blade assembly. Do not use scouring
powder to clean the jars as it would leave marks. To
remove traces of water from the blade assembly, run the
mixer-grinder with the empty jar for 10 seconds.
•Clean the jar lid with a dry cloth to avoid unpleasant odour
when the mixer is taken up for use again.
•Do not wash the base unit or immerse it in water as it
could cause electrical hazards. Wipe the base unit clean
with a damp cloth to remove stains, if any and then wipe
with a dry cloth to keep the base unit dry and clean.
GUARANTEE
Every BAJAJ JUICER MIXER GRINDER is GUARANTEED against manufacturing defects for a
period of TWO years from the date of purchase. While purchasing a Bajaj Juicer-Mixer-Grinder
insist on a Cash Memo and the Guarantee Card duly filled in by the dealer. Preserve the
Guarantee Card and the Cash Memo carefully.
At Bajaj, we continuously endeavour for improvement. Therefore the specifications are subject
to change without notice.
