BakerStone PIZZA User manual

Unpacking the Pizza Oven Box
What’s in the package
Assembly of the Pizza Oven Box
What’s Needed to Bake Pizza
How To Use the Pizza Oven Box
Care Instructions
Customer Service
Frequently Asked Questions
3
5
6
9
10
13
13
14
Table of Contents Page
Product Guide
2

STEP 6. Gently remove the oven from the Styrofoam Block
(S). Discard the protective plastic bag.
A
4
Step 5. With one Styrofoam Block (S) removed, gently
remove the brown cardboard box (CB)that contains the
stones. Remove the tape from this cardboard box and
place each stone gently on an even, soft surface.
NOTE: The stones are fragile, handle the cardboard box
(CB) with care.
CB
S
S
Product Guide

Assembly of the Pizza Oven Box
STEP 1. Place the HOUSING (A) carefully upside down on
a clean, soft surface. NOTE: Failure to do so may result in
scratching or denting the Pizza Oven Box.
STEP 3. Identify the TOP STONE (D), this is the largest stone
in the box. NOTE: There are notches on both sides of this
stone.
STEP 4. Gently fit the TOP STONE (D) into the Stone
Cradles of the HOUSING (A).
STEP 5. Identify the 2 SIDE STONES (F). Fit the 2 SIDE STONES
into the notches of the TOP STONE (D). NOTE: The flat end
of the SIDE STONES (F) should face the Front of the oven.
6
D
F
A
D
A
D
Notch
Stone
Cradles
STEP 2. Remove the BACK PANEL (B) from the HOUSING
(A) by removing its 4 SCREWS (J) and 4 FLAT WASHERS
(H). You will identify the BACK PANEL (B) by the em-
bossed Bakerstone flame logo on this panel.
B
B
A
A
J
H
Product Guide

STEP 7. Fit the remaining REAR STONE (G) into the notches
of the 2 SIDE STONES (F).
STEP 8. Place the BACK PANEL (B) back onto the
HOUSING (A) and secure with 4 SELF TAPPING SCREWS (J)
and 4 FLAT WASHERS (H). NOTICE: Do not over tighten
screws, cracking of the enamel finish may occur.
G
F
STEP 6. The other large stone is the BASE STONE (E). Fit this
in between and on top of the 2 SIDE STONES (F).
J
H
B
7
E
E
F
A
F
Product Guide