Ballard Designs WH030 User manual

Prevent accidentally discarding small parts or
hardware. Retain all carton contents until assembly
and installation are complete.
PRODUCTS ARE NOT INTENDED
FOR COMMERCIAL USE.
UPDATED: 9-4-2020 Page 1 of 4
PRODUCT NAME: Marble Floor 2 Tier Towel Holder
ITEM NUMBER: WH030
ASSEMBLED DIMENSIONS : 39”H x 29”W x 9”D
MADE IN CHINA
Customer Service: 800-367-2810
Online: www.ballarddesigns.com

Page 2 of 4
Ltr.
A 4
B 2
Qty. Hardware Included
Ltr.
E
K
4
2
Qty. Components
C4
REQUIRED TOOLS:
Phillips Allen Key (included)
-Two person assembly suggested.
Remove all parts, hardware and
protective packaging from carton
and carefully arrange on a clean,
level, padded surface.
F
G
H
I
J
8
2
2
1
2
Cleaning and Care
Periodically dust surface once or twice a week with a soft cloth.
Periodically wash marble with a cloth dampened with warm water.
Do not use harsh chemicals, abrasives or polishers.
Finials (E)
Rings (F)
Support Bars (H)
Towel Bars (G)
Marble Base (I)
Front Support Posts (J)
Back Support Posts (K)
D1
Flat Washer
Customer Service: 800-367-2810
Online: www.ballarddesigns.com
Short Machine Screws
M6 x 30mm
Long Machine Screws
M6 x 130mm
Allen Key
with Phillips End
Assemble in location for intended use.

(J)
(K)
(H)
(B)
This side up.
(C)
Page 3 of 4
(F)
(A)
(I)
Customer Service: 800-367-2810
Online: www.ballarddesigns.com
STEP 1: Orient Front Support Posts (J) and Back Support Posts (K) as shown then join each pair
using a Support Bar (H). Insert and tighten Long Machine Screw (B) through hole in Back Support
Post, through Support Bar and into Front Support Post. Gently and fully tighten using Allen Key (D).
Do not overtighten screws
Top (up)
Bottom (down)
STEP 2: Orient Marble Base (I) with finished side up then align both Support Post Assemblies with
holes, add a Ring (F) to bottom of each Post, insert Short Machine Screws (A) with Flat Washers (C)
and fully tighten using Allen Key (D).
(F)
Assemble in location for intended use.

This side up.
(G)
(E)
Page 4 of 4
Customer Service: 800-367-2810
Online: www.ballarddesigns.com
(F)
Assemble in location for intended use.
STEP 3: Set partially assembled unit on a level surface then add a Ring (F) to top of each Support
Post (orient as illustrated). Add a Towel Bar (G) to each assembly, front and back. Secure in place by
threading and tightening a Finial (E) into top of each Post.