B&W Tek BDS100 User manual

19 Shea Way, Newark, DE 19713 •Tel: [phone] •Fax: [phone] •Web: www.bwtek.com
290020059-E (09/01/2015) Copyright 2015 B&W Tek, Inc.
BDS100
Deuterium/Tungsten
Light Source
User Manual

19 Shea Way, Newark, DE 19713 •Tel: [phone] •Fax: [phone] •Web: www.bwtek.com
290020059-E (0901/2015) Page 2of 3Copyright 2015 B&W Tek, Inc.
INTRODUCTION
The BDS100 is a fiber-coupled UV/Vis/NIR light source (fiber not included) delivering a spectral
output range of about 200-1100nm. The UV lamp generates low heat and has low power
consumption. The light source comes complete with a 12 V DC power supply, safety shutter,
and individual On/Off controls for the Deuterium and Tungsten lamps.
SAFETY INFORMATION
The miniature UV/Vis/NIR light source of the BDS100 is a high-voltage lamp (over 1000 Volts)
which operates at a high exciting frequency of 250 kHz and produces UV radiation.
Radiation from direct or reflected UV light may burn your skin and eyes. Protect your eyes by
wearing goggles with clear or tinted lenses.
Safety and proper functioning of the light source can only be guaranteed if original parts and
replacement parts from B&W Tek, Inc. are used.
Specifications
See Product Datasheet for specifications.
BDS100 UV/Vis Light Source
BDS100 Rear View
BDS100 Front View

19 Shea Way, Newark, DE 19713 •Tel: [phone] •Fax: [phone] •Web: www.bwtek.com
290020059-E (0901/2015) Page 3of 3Copyright 2015 B&W Tek, Inc.
Installation
Connect 12 V DC power adapter to the rear panel receptacle. The front green LED will turn on.
Operation
1. Clean the fiber’s SMA connectors by using a fiber optic connector cleaner or a cotton swab
moistened with isopropyl alcohol
2. Connect a fiber to the excitation port located on the front panel
3. Leave the S (shutter) switch in the OFF position
4. Turn ON the W (Tungsten) switch or D2 (Deuterium) switch or both
5. Let the source warm up for 8 -10 minutes
6. Turn ON the S (shutter) switch to open the shutter
LEDs
Front LED - green LED will turn on when the power supply is connected.
Rear LEDs - red LED will turn on next to the corresponding toggle switch.
W for Tungsten On
D2 for Deuterium On
S for Shutter Open
Dimensions (Inches)