Barbie Switchboard B1613 User manual

D
i
s
c
o
v
e
r
w
h
a
t
’
s
p
o
s
s
i
b
l
e
™
…
w
w
w
.
f
i
s
h
e
r
-
p
r
i
c
e
.
c
o
m
Product Number: B1613, B1614
Please keep this instructions sheet for future reference,
as it contains important information.
No adult assembly is required.
Adult assistance is required to adjust the handle up or down.
Ages 5 - 7 years. Weight Limit: 100 lbs. (45 kg).
Protective equipment shown in these photos is not included.
Skateboard
Scooter
®
™

2
WARNING
To prevent injury:
• Keep away from cars, streets, steep inclines, steps,
swimming pools or other bodies of water.
• Protective equipment should be worn. Use helmet,
wrist guards, knee pads and elbow pads.
• Always wear shoes.
• Never allow more than one (1) rider.
• Never ride at night.
Safety
Safety T Tips ips
IMPORTANT! Please take a few moments to review the following
safety tips with your rider.
• Be sure an adult adjusts the handle up for scooter use and down for
skateboard use.
• Your rider should wear shoes or sneakers that provide good support.
• Your rider should not wear open-toe shoes.
• Your rider should wear a helmet, knee pads, wrist guards and elbow pads
to guard against bumps and bruises.
• Keep loose laces and pant legs away from the wheels.
• Supervise beginners. Hold the beginner’s hand and guide the new rider
along a smooth, level surface.
• Choose areas for riding that are free of obstacles, and avoid wet or
uneven surfaces.
• Make sure your rider never rides on streets, roadways and driveways
which enter vehicle traffic routes.
• Towing riders with bicycles or cars is unsafe.

3
Adjusting the
Adjusting the T Trucks rucks
• Turn Switch Board™upside-
down on a flat surface.
Locate both trucks on each
end of the board.
Hint: Be sure to place a sheet
or towel on the surface to
protect it.
• Using an adjustable wrench:
- Turn each nut clockwise for a
stiff setting.
- Turn each nut counter-clock-
wise for a loose setting.
Hint: You should not need to
loosen the nut more than a few
turns for a loose setting.
IMPORTANT! Check to be
sure you have not loosened
the trucks too much! Pull on
both trucks. The trucks should
remain on the board. If you can
remove either of them, you have
loosened the truck(s) too much.
Replace the truck(s) and tighten
the nut(s) clockwise with an
adjustable wrench.
The Switch Board™trucks are adjusted at the factory to the stiffest setting (for
beginner use). The stiff setting provides the greatest stability. As your child
becomes more comfortable and is better able to balance on Switch Board™,
you can adjust the trucks (to a loose setting) to allow greater steering control.
Counter-Clockwise
for Loose Setting
Truck
Clockwise for
Stiff Setting

Scooter
Scooter
Note: Protective equipment in
this illustration is not included
with this toy.
Handle Up
• Place Switch Board™on its side with the handle towards you.
• Pull the adult latch out completely , to unlock the handle. While holding the
adult latch out with one hand, pull the handle outward slightly (about two
inches) with the other hand. Release the adult latch .
• Continue to rotate the handle to the upright position.
•Push the adult latch until it “snaps” into place . Make sure you
hear a “snap”. The end of the adult latch should align with the lock
line .
• Position Switch Board™upright. Push the handle back to be sure it is secure.
Hint: To balance, your rider needs to stand on the center area of the
Switch Board™!
Handle
Adult Latch
1
1
2
3
3
Adult Latch
Adult Latch
Lock Line
PUSH
Handle Up
Handle Up
2
4
PULL
Fisher-Price, Inc., a subsidiary of Mattel, Inc., East Aurora, NY 14052 U.S.A. Printed in China
©2002 Mattel, Inc. All Rights Reserved. ® and ™ designate U.S. trademarks of Mattel, Inc. B1613pr-0920

5
Skateboar
Skateboard d
1
2
3
• Place Switch Board™on its side with the handle toward you.
• Pull the adult latch out completely , to unlock the handle. While holding
the adult latch out with one hand, push the handle down slightly (about two
inches) with the other hand. Release the adult latch .
• Continue to rotate the handle completely down.
•Push the adult latch until it “snaps” into place . Make sure you
hear a “snap”. The end of the adult latch should align with the lock
line .
• Position Switch Board™upright. Pull the handle up to be sure it is secure.
Hint: To balance, your rider needs to stand on the center area of the
Switch Board™!
Handle
Adult Latch
Adult Latch
Adult Latch
PUSH
PULL
Lock Line
Handle Down
Handle Down
Note: Protective equipment in
this illustration is not included
with this toy.
Handle
Down
1
2
3

Car
Care e
Consumer Information
Consumer Information
Questions? We’d like to hear from you!
If you’d like to order replacement parts, or if you have any questions about this
product, please call Fisher-Price®Consumer Relations, toll-free at 1-800-432-5437,
8 AM - 6 PM EST Monday through Friday. Hearing-impaired consumers using
TTY/TDD equipment, please call 1-800-382-7470. Or, write to: Fisher-Price®
Consumer Relations, 636 Girard Avenue, East Aurora, New York 14052.
Canada: call 1-800-567-7724, or write to: Mattel Canada Inc., 6155 Freemont Blvd., Mississauga, Ontario L5R 3W2.
Great Britain: telephone [phone].
Australia: Mattel Australia Pty. Ltd., 658 Church Street, Locked Bag #870, Richmond, Victoria 3121 Australia.
Consumer Advisory Service 1300 135 312.
New Zealand: 16-18 William Pickering Drive, Albany 1331, Auckland.
• Periodically inspect Switch Board™for wear or damage. Check all nuts and
bolts and tighten as required.
• To clean, use a mild soap and water solution and clean cloth. Rinse clean with
water to remove soap residue.
• This product has no consumer serviceable parts. Please do not take this
product apart.