Barton 96001 Original instruction manual

SAVE THIS MANUAL: KEEP THIS MANUAL FOR SAFETY WARNINGS, PRECAUTIONS, ASSEMBLY,
OPERATING, INSPECTION, MAINTENANCE AND CLEANING PROCEDURES. WRITE THE PRODUCT’S
SERIAL NUMBER ON THE BACK OF THE MANUAL NEAR THE ASSEMBLY DIAGRAM (OR MONTH
AND YEAR OF PURCHASE IF PRODUCT HAS NO NUMBER).
OWNER’S MANUAL AND SAFETY INSTRUCTIONS
ITEM: 96001
FOR QUESTIONS PLEASE CALL OUR CUSTOMER SUPPORT: [phone] MON-FRI 9AM TO 3PM PST
STOVETOP ALUMINUM POPCORN POPPER

1
GENERAL SAFETY WARNINGS
The warnings, precautions, and instructions discussed in this instruction manual cannot cover all possible
conditions and situations that may occur. It must be understood by the operator that common sense and
caution are factors which cannot be built into this product, but must be supplied by the operator. Read
carefully and understand all instructions before operating. Failure to follow the safety rules and other basic
safety precautions may result in serious personal injury.
NEVER leave the popper unattended while in use. Keep out of reach of children.
Check to be sure the handle is securely fastened to the popper before popping
Make sure the lid is securely fastened to the kettle before popping.
ALWAYS use caution when the popper is hot.
Wash your popper in mild, soapy water before and after popping to keep your popper clean.
Close the lid before popping, remove from the stove when done popping.
For household use only, do not use this popper for anything other than its intended use.
DO NOT put your face or hands near popper lid when freshly popped to avoid steam burns.
DO NOT put the popper in the microwave oven.
DO NOT put the popper in the dishwasher, wash by hand only.
DO NOT pop popcorn in the popper without cooking oil. Spray oils are NOT sufcient for use with the
popper.
DO NOT use the popper when there is water in the popper. Doing so will cause the oil to pop.
DO NOT use sugar or cheese as these may burn or explode when heated to high temperature.
DO NOT set an empty popper on a heated stove, doing so can cause damage to the popper.
DO NOT EVER use water to put out an oil re; use a re extinguisher or use baking soda instead.
NEVER allow children to use the popper.
IMPORTANT SAFETY INFORMATION

2
1. Add one tablespoon of vegetable oil into the popper.
PRIOR TO FIRST USE
2. Tilt the popper to coat the bottom and sides.
3. Heat for 20 seconds or until the oil is hot. DO NOT leave the popper unattended.
4. Remove the popper from the stove and let it cool down.
5. Wipe out the oil in the popper with the napkin and you can start popping.
POPPING POPCORN
1. DO NOT add any ingredients while the popper is on any heat source.
2. Use the proper amounts of popcorn and oil. 1/2 cup popcorn and 1/3 cup of oil.
3. Hybrid popcorn such as white, crimson or petite pop up smaller and should be adjusted accordingly.
1. Assemble the pot and lid.
POPPING PROCESS
2. Place the assembled popper on the stove and heat
at medium heat for about a minute.
3. Open the lid and add the oil into
the pot.
4. Close the lid and stir the popcorn with the poppers
handle for about three minutes.
OPERATION

WARRANTY
3
THE MANUFACTURER AND/OR DISTRIBUTOR HAS PROVIDED THE PARTS LIST AND ASSEMBLY
DIAGRAM IN THIS MANUAL AS A REFERENCE TOOL ONLY. NEITHER THE MANUFACTURER OR
DISTRIBUTOR MAKES ANY REPRESENTATION OR WARRANTY OF ANY KIND TO THE BUYER THAT
HE OR SHE IS QUALIFIED TO MAKE ANY REPAIRS TO THE PRODUCT, OR THAT HE OR SHE IS
QUALIFIED TO REPLACE ANY PARTS OF THE PRODUCT. IN FACT, THE MANUFACTURER AND/OR
DISTRIBUTOR EXPRESSLY STATES THAT ALL REPAIRS AND PARTS REPLACEMENTS SHOULD BE
UNDERTAKEN BY CERTIFIED AND LICENSED TECHNICIANS,AND NOT BY THE BUYER. THE BUYER
ASSUMES ALL RISK AND LIABILITY ARISING OUT OF HIS OR HER REPAIRS TO THE ORIGINAL
PRODUCT OR REPLACEMENT PARTS THERETO, OR ARISING OUT OF HIS OR HER INSTALLATION
OF REPLACEMENT PARTS THERETO.
PLEASE READ THE FOLLOWING CAREFULLY
Record Product’s Serial Number Here:
Note: If product has no serial number, record month and year of purchase instead.
Note: Some parts are listed and shown for illustration purposes only and are not available individually
as replacement parts.
PRODUCT MADE IN CHINA